Extron Flex55 100 Mounting Kit Series Manual

Extron Flex55 100 Mounting Kit Series Manual
Flex55 100 Mounting Kit Installation Guide
T: complete
Extron Flex55 100 Mounting Kits are designed to mount Extron Flex55 modulesOonto
TANrExtron
d
the
s, an
P nR
om fo struction the
M
I
.c
o
Flex55 enclosures and EU junction boxes. The mounting kits include a mounting
xtr frame
ting
n in nand
c
.e
o
e
ti
w
a
ww install
con urce.
Go to uThe
e, mounting
so kits
efore
bracket. Each bracket opening holds one full module or two half modules.
g id
ns b e power
user cificatio
th
e
uct to
d
accommodate Extron Flex55 modules such as Extron Flex55 SuperPlatesp100,
ro
p
DTP T EU 4K DTP transmitter, and EBP EU button panels.
Kit Contents
IMPORTANT:
Extron
Refer to www.extron.com for the complete
user guide, installation instructions, and
specifications before connecting the
product to the power source.
Removal Tool
Mounting Bracket
and M3 Wafer Head Screws
Raceway Spacer
Mounting Frame
Installation in a Surface Mount Box or Wall Box
Follow these steps to install Flex55 modules in a surface mount box or in a wall box.
NOTE:
Some modules are difficult to remove once installed. Make sure the wiring is
correct before snapping in each module at step 3.
the mounting bracket
1 Secure
to the box using the provided
M3 screws.
M3
screws
the mounting frame
2 Position
on the bracket.
cables to the
3 Connect
Flex55 modules and
snap the modules into
the bracket.
RD
CO
RE
K
Extron SMB 212
Mounting
Bracket
R
TO
MAR
E
AG
BS
US
on
Extr
Mounting
Frame
Extron Flex55 Modules
Installation in a European Raceway Channel
Follow these steps to install a Flex55 module into a raceway.
Junction Box
the raceway spacer and
1 Secure
bracket to the junction box using
the provided M3 screws.
the frame on
2 Position
the bracket.
Bracket
Raceway
Spacer
(optional)
Cable
Raceway
cables to the
3 Connect
Flex55 module and
snap the module into
the installed bracket.
Frame
Extron Flex55 Module
Removing a Flex55 Module
Follow these steps to remove an installed Flex55 module.
Extron
Extron
Extron
Locking
Tabs (2)
Removal Tool
the locking tab
1 At
locations, insert the
removal tool up to the
arrow.
For modules with one locking tab,
unhook the tab located at the center.
For half modules, the tab is located as
shown below:
Locking
Tab (1)
FF
O
E
ONLUM
each locking tab from
the bracket.
the
3 Remove
module.
on
Extr
AY
PL
DIS
the removal tool
2 Pull
to the left to unhook
VO
PC
Extron
Locking
Tab (1)
68-3060-50
Rev. A
05 17
© 2017 Extron Electronics — All rights reserved. All trademarks mentioned are the property of their respective owners. www.extron.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement