Troy-Bilt 23A1AXA766 FLEX™ Power Base Fast Start Guide

Troy-Bilt 23A1AXA766 FLEX™ Power Base Fast Start Guide
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
1
To rest the FLEX™ Power Base after unpacking
it from the shipping carton, and/or when no
attachment is present, a convenient Latch’n
Lock™ kickstand has been provided on the rear
of the unit. Simply deploy the Latch’n Lock™
kickstand to park the FLEX™ Power Base when no
attachment is present.
3
C
Attachment
Control Safety
Lock
On/Off Switch
Handle Adjustment Knob
Attachment
Control Lever
C
Tighten the handle adjustment knobs (C) to firmly
secure the upper handle and support tubes.
Note: The convenient handle adjustment knobs
(C) are available for the operator to simply make
a handle adjustment, based on preference and/or
application, quickly, and easily.
Remove any packaging material from the
upper handle.
2
Loosen the handle adjustment knobs (A)
and pivot the upper handle assembly
upwards (B) until it reaches the optimal
operating position based on the operator’s
preference.
Note: The handles
can only be put into 3
positions.
A
To put the handlebars in the stowed
position loosen the handle adjustment
knobs (A), and pivot the upper handle
assembly downwards (B) until it reaches the
bottom of it’s pivot motion.
Drive Control
Lever
4
Lightly tighten the two handle adjustment
knobs (C) to secure the upper handle into
stowed position.
Latch‘n
Lock/
Kickstand
A
B
B
A
© 2015 23A-1AXA
A
778-13408
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
5
8
Add the oil included
in manual bag to the
engine. (Refer to the
Operator’s Manual)
Fill fuel tank with clean,
fresh gasoline. Do not fill
above the base of fuel
tank neck.
Push primer
3-5 times (Cold
weather only).
Make sure you
cover the vent
hole with your
thumb.
Oil Fill Cap
Hold the primer
bulb in for one full
second each time
you press it.
Fuel Cap
Cold Weather/Warm
Weather Control
Turn Cold Weather/Warm Weather
Control knob to appropriate position.
9
Note: Cold weather is
Cold Weather
below 320F and warm weather
is above 320F.
6
Key
Insert the key
into the key
switch until
the key snaps
into place.
Warm Weather
Do not turn
the key!
7
10
Move the choke
control
into the Full
Choke
position.
Note: Engine
needs to be
choked when
the engine is
cold in warm
weather. It must be choked every time in cold
Recoil Starter
Primer
Choke
weather. Refer to starting label.
© 2015 23A-1AXA
Pull starter rope
with quick, full
arm stroke. When
engine starts,
slowly move choke
control into the
RUN
position.
778-13408
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement