Troy-Bilt 13AN77KS011 Pony Riding Lawn Mower Fast Start Guide

Troy-Bilt 13AN77KS011 Pony  Riding Lawn Mower Fast Start Guide
Read and understand all instruction, warning, and danger labels.
Para instrucciones en Español, refiérase al Manual del Operador.
1
1. With the wheels of the tractor
pointing straight forward,
place the steering wheel
over the steering shaft.
Attach the red cable to the positive (+) battery
terminal and attach the black cable to the
negative (–) battery terminal with the bolts and
hex nuts.
3
2. Secure the steering
wheel with the washer
(cupped side down)
and hex bolt.
Position the red rubber boot over the
positive battery terminal.
3. Push the steering
wheel cap downward
until it “clicks” into
place.
Throttle
Control
4
2
Remove the shipping brace from the
discharge opening by grasping it
between your thumb and index finger
and rotating it clockwise.
Attach the dash collar
with the two screws
found in either side
of the dash console.
Ignition
Switch
Brake
Pedal
1. Remove the knob from the base of the
seat.
Shift
Lever
Knob
Tools Required:
•
9⁄16-inch wrench (or adjustable wrench)
•
7⁄16-inch wrench (or adjustable wrench)
•
1/2-inch socket wrench
PTO (Blade
Engage) Lever
© 2010 13AN77K
5
2. Position the seat over
the seat pan, with
the two forward seat
mount tabs fitting into
the provided grooves.
3. Slide the seat rearward
and align the center
mounting hole in
the seat with the slot
in the seat pan and
secure the seat with
the knb.
Form No. 778-11998
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE important SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U
Read and understand all instruction, warning, and danger labels.
Para instrucciones en Español, refiérase al Manual del Operador.
6
Fill fuel tank with clean, fresh gasoline.
Do not fill above the base of fuel tank neck.
Move the throttle control
into the Choke
position
9
Place PTO (Blade Engage) Lever in Off position.
Throttle
Control
7
Place Shift Lever in N (neutral) position.
10
Ignition
Switch
Brake
Pedal
Insert the ignition key and turn it to the Start
position.
Release the key after the engine starts.
8
Fully depress the Brake Pedal.
Shift
Lever
11
PTO (Blade
Engage) Lever
Note: Steering Wheel not shown for clarity.
© 2010 13AN77K
Move Throttle to Fast
position.
Form No. 778-11998
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
and FOLLOW THE important SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement