Troy-Bilt 24BF572B711 Log Splitter Fast Start Guide

Troy-Bilt 24BF572B711 Log Splitter Fast Start Guide
Read and understand all instruction, warning, and danger labels.
Lea el manual de operación anexo sobre ensamblaje e inicio.
1
4
Dislodger
Control Handle
Cylinder
Pivot jack stand to
operating position.
Wedge
Beam
Log Cradle
Jack Stand
Remove dislodger and log cradle as shown.
Tongue
5
2
Remove hardware from tank bracket. Align holes of
tongue with those in bracket and secure with hardware
just removed.
Lift and slide
cylinder to top
of beam and into
weld brackets.
B
Pivot beam to horizontal
position and lock.
2
1
A
© 2007 24BF572B
3
IMPORTANT: Lubricate beam, adjust wedge assembly, and check hydraulic
fluid before operating. Refer to Operator’s Manual for instructions.
Need Help?
Call 1-888-TO-HELP-U
6
Re-attach dislodger and log cradle.
(1-888-864-3578)
IMPORTANT: READ OPERATOR'S MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
778-11261A
Read and understand all instruction, warning, and danger labels.
Lea el manual de operación anexo sobre ensamblaje e inicio.
10
7
Fill tank with gas to within 1/2 inch of top of tank. Open
fuel valve.
Pull starter rope with quick, full armstroke. If engine
does not start after ten seconds of repeated pulls, wait
a few minutes and repeat.
8
Choke
Turn engine switch to ON position.
IMPORTANT: Lubricate beam, adjust wedge assembly, and check hydraulic
fluid before operating. Refer to Operator’s Manual for instructions.
Pull CHOKE out.
9
Need Help?
Call 1-800-800-7310
11
Push CHOKE in after engine starts.
IMPORTANT: READ OPERATOR'S MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement