Troy-Bilt 24A424G711 Log Splitter Fast Start Guide

Troy-Bilt 24A424G711 Log Splitter Fast Start Guide
Read and understand all instruction, warning, and danger labels.
Lea el manual de operación anexo sobre ensamblaje e inicio.
3
1
A
(A) Pull spring latch
upward.
B
Insert tow bar
into base and
secure with
clevis pin and
spring pin.
(B) Pivot chipper chute
down until it clicks into
lock rod.
Spring Latch
Chipper Chute
Chute Deflector
Remove spring
pin and clevis
pin from hitch
mounting base.
Tow Bar
Knobs
Hitch Mounting Base
2
© 2007 24A-424G
Lock Rod
4
Place opening of bag over the chute deflector and
knobs. Pull the drawstrap until the bag is tight around
chute deflector opening.
Need Help? Call 1-888-TO-HELP-U (1-888-864-3578)
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
778-11420
Read and understand all instruction, warning, and danger labels.
Lea el manual de operación anexo sobre ensamblaje e inicio.
8
5
Gas Cap
Fill tank with gas to within 1/2 inch of top of tank.
Use choke lever to choke engine.
Choke Control
6
Throttle Control
Fill engine with entire contents of oil bottle.
Oil Fill
Starter Rope
Move throttle on engine to FAST position.
(If engine is equipped with on/off switch, move switch to
ON position)
7
Need Help?
Call 1-800-800-7310
9
Pull starter rope with quick, full armstroke. If engine does
not start after ten seconds of repeated pulls, wait a few
minutes and repeat this step. When engine starts, slowly
move choke to RUN position.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement