ProRestore Unsmoke Degrease-All E User Guide

ProRestore Unsmoke Degrease-All E User Guide
Unsmoke® Degrease-All E™
FOR PROFESSIONAL USE ONLY
LegendBrandsRestoration.com
High performance electronics cleaner
BACKGROUND
It is well known that structural fires deposit a great deal of soot, debris and greasy soils on electronic components that were in the
building at the time of the fire. Structure fires that involve certain synthetic materials such as vinyl plastic also produce acidic vapors.
These vapors can corrode the exposed metal components in electronic devices. Degrease-All E is specially designed to clean,
neutralize and degrease these exposed metal components.
Degrease-All E contains water soluble solvents, corrosion inhibition agents, soil suspension agents, grease cutting surfactants and
alkaline builders. The product loosens, emulsifies and suspends particulate and greasy soils. The alkaline builders in Degrease-All E
neutralize acidic residues. Degrease-All E is fully water soluble so it can be rinsed off surfaces and leaves no residue.
ITEMS NEEDED
• Cleaning products: Degrease-All E
• Personal Protective Equipment (PPE) as specified in the Safety Data Sheet (SDS)
• Supplies: adequate supply of clean cloths and a plastic bag for the storage of soiled cloths, measuring cup, source of purified (for
example: deionized or distilled) water, hand trigger sprayer, wide mouth container, soft brush,
• Equipment: ultrasonic cleaning equipment, source of compressed air or heat
PRETESTING: Test surfaces or items to be cleaned in inconspicuous area to check for potential damage or adverse reaction.
PROCEDURE
Pre-conditioning: Prepare a ready-to-use (RTU) solution by diluting 12 ounces of concentrate with enough hot tap water
(94 mL/L) to make one gallon. Place in hand trigger sprayer. Lightly spray smoke damaged surfaces, agitate with soft brush. Increase
the concentration to as much as 32 ounces per gallon (250 mL/L) depending on soiling conditions.
Brush on application: Prepare a ready-to-use solution of Degrease-All E by diluting 12 ounces of concentrate with enough hot tap
water (94 mL/L) to make one gallon and place in wide mouth container. (Increase the concentration to as much as 32 ounces per gallon
(250 mL/L) depending on soiling conditions.) Use a soft brush to apply or agitate the RTU solution on target surfaces. Rinse with
deionized or distilled water until no soap bubbles are visible. Remove moisture by blowing with compressed air and oven drying.
Ultra-sonic cleaning: Add 2 ounces of concentrate per gallon (16 mL/L) of water in cleaning tank. Rinse with purified water after
cleaning.
Siphon application: Prepare a ready-to-use solution by diluting 12 ounces of concentrate with enough hot tap water
(94 mL/L) to make one gallon. (Increase the concentration to as much as 32 ounces per gallon (250 mL/L) depending on soiling
conditions.) Place in detergent reservoir. Spray soiled surfaces until clean and then rinse with purified water until no soap bubbles are
visible. Remove moisture by blowing with compressed air and oven drying.
CLEAN UP
•
•
•
•
•
Check all PPE for damage. Repair or replace as needed.
Clean the outside of the spraying equipment to remove soot and soils. This will help to prevent cross-contamination and will
maintain your professional image on the next job.
Rinse containers and extraction equipment to remove product residues and waste water. Be sure to dispose waste water
properly. Never dispose into surface waters, on the ground or into a storm drain.
Flush the sprayer with detergent and then rinse with water to remove any product residue. Empty water from the sprayer,
especially in cold climates where freezing is possible.
Wash hands after using the product.
Sales/Tech support: 800-932-3030 • Technical support: 800-332-6037 • Emergency: 800-535-5053
PR_DegreaseAll-E_UserGuide_RevB.docx
1
Legend Brands
SAFETY CONSIDERATIONS
• IMPORTANT: The odor of this product may be irritating to some persons with allergic sensitivity. It is recommended to allow
•
•
•
•
•
•
occupants to “sniff test” the product prior to application. For “sniff testing” prepare the ready-to-use solution and dip a note card
or business card into the solution. Allow occupant to “sniff” both wet and dried solution. Obtain permission from occupants
prior to product application. Individuals may reoccupy treated spaces when they feel physically comfortable and/or upon
advice of their consulting physician.
Keep children and pets away from chemical products, equipment and the work area.
Read the Safety Data Sheet (SDS) for any chemical product before using it. You can obtain the SDSs for ProRestore Products
from your distributor or from LegendBrandsRestoration.com
Be sure electrical equipment including plugs and extension cords are in good condition.
Be sure to wipe any surfaces where there has been a spill of the product
Wash hands after using the product.
Be sure to use personal protective equipment. Depending on the nature of the damage in the building, this could include hard
hats, heavy soled shoes, full protective suits or aprons. In every instance when spraying solutions overhead or in your
breathing zone you should use eye protection, gloves and respiratory protection. If using ultra sonic cleaning equipment,
remember that is equipment generates significant noise. Use hearing protection anytime the generator is activated.
Where to use: Water-cleanable electronic components. Do not use on items damaged by water, alkali or glycol solvents.
ADDITIONAL REFERENCES
• User Guides and Safety Data Sheets (SDS) for all ProRestore
Products are available at LegendBrandsRestoration.com
• Restoration Sciences Academy Odor Certification Classes. For
location and scheduling of classes, go to
LegendBrandsRestoration.com.
• For technical support call 800-332-6037 (USA) or 800-233-6037
(Canada)
• For medical advice related to exposure to this product, call Infotrac
at 800-535-5053 (USA and Canada) / 352-323-3500 (worldwide).
DEGREASE-ALL E TECHNICAL DATA
Re-order number
Color
Odor
Appearance
Flash point
Specific gravity
Density
pH of concentrate
VOC content
Phosphate content
Surfactant type
Storage
161242EEE case (4 x 1 gallon)
Colorless
Ammonia, glycol solvent
Transparent liquid
> 200°F (93°C)
1.03
8.6 pounds per gallon
11.6
Trace
Less than 2%
Nonionic
Protect from freezing.
Sales/Tech support: 800-932-3030 • Technical support: 800-332-6037 • Emergency: 800-535-5053
PR_DegreaseAll-E_UserGuide_RevB.docx
2
Legend Brands
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement