- Computers & electronics
- Print & Scan
- Printing supplies
- Toners & Laser Cartridges
- Copystar
- ECOSYS FS-1370DN
- Installation Guide
advertisement
Clearance
FS-1370DN
300 mm (11-13/16") 300 mm (11-13/16") 200 mm (7-7/8")
200 mm
(7-7/8")
500 mm (19-11/16")
Installation Guide
Environment
• Temperature: 10 to 32.5 °C (50 to 90.5 °F)
• Humidity: 15 to 80 %RH
• Power Supply: 120 V AC, 60 Hz / 220 to 240 V AC, 50/60 Hz
CAUTION: Be sure to provide enough space around printer. Prolonged use without sufficient clearance may cause overheating.
Important: Do not install the printer where temperature or humidity is outside the recommended range. Print quality may suffer and there will be an increased chance of paper jams.
1
1
Unpacking
Unpack the printer and all its included components.
2
Remove the packing item.
3
Check the parts and components.
CD-ROM Manuals and Other
Printed Materials
Printer
Toner Container Power Cord
2
1
Installing the Toner Container
Open the top cover.
2
Turn the lock lever to the unlock position.
3
Take the toner container from the bag.
Shake the new toner container at least
5 times as shown in the figure in order to distribute the toner evenly inside the container.
4
Remove the label from the toner container.
5
Install the new toner container into the printer.
6
Push firmly on the top of the container at the positions marked PUSH , until you hear a click.
7
Turn the lock lever to the lock position.
8
Close the top cover.
3
1
Loading Paper
Pull the paper cassette all the way out of the printer.
2
Adjust the paper length guide to fit the paper size.
3
Adjust the paper width guides to fit the paper size.
4
Fan the paper, then tap it on a level surface to avoid media jams or skewed printing.
5
Load paper in the cassette, with the side to be printed downward.
Important: Do not exceed the upper limit of the cassette. Otherwise, it may cause paper jams.
6
Insert the paper cassette into the slot in the printer. Push it straight in as far as it will go.
4
1
Connecting Cables
Connect the printer to the PC or your network device. Use shielded interface cables. These cables are sold separately.
Note: Remove the cap, when using the network interface.
2
Connect the power cord to the printer and the other end into a power outlet.
5
1
Selecting the Message Language
Turn the power switch on (|).
Important: The printer will begin replenishing the toner; this will take approximately
15 minutes.
2
Wait until the message display indicates Message Language . The default message language is English .
Important: Message Language may not appear according to the destination.
3
To change the language, press [ U ] or [ V ] repeatedly until the message display shows the desired language.
4
Press [OK] . The message language will be changed.
Refer to the Operation Guide to install the printer driver and to set network parameters.
© 2010 by KYOCERA MITA Corporation All rights reserved. 2-28, 1-Chome, Tamatsukuri, Chuo-ku, Osaka 540-8585, Japan Printed in China 302L056020 First edition 2010.3
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project