Toro Plow Mount Cable Guide Kit, RT1200 Trencher Installation Instruction

Toro Plow Mount Cable Guide Kit, RT1200 Trencher Installation Instruction
Form No. 3407-261 Rev A
Plow Mount Cable Guide Kit
RT1200 Trencher
Model No. 25407
Model No. 25407E
Installation Instructions
Note: The machine must be equipped with the Vibratory Plow Kit.
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals known to the State of California to
cause cancer, birth defects, or reproductive harm.
Preparing the Machine
Installing the Cable Guide
1. Move the machine to a level surface.
2. Set the parking brake and lower the attachments to
the ground.
Installing the Brackets
3. Stop the engine and remove the key.
4. Remove the hardware on the shaker box.
© 2016—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Right bracket
Left bracket
Bolt 5/16 x 1-1/4
inch
1x
1x
16 x
Original Instructions (EN)
Printed in the USA
All Rights Reserved *3407-261* A
Assembling and Installing the Cable Guide
Cable guide
Clevis pin
Hair pin
Bolt (1/2-13 x
2 inch)
Washer
Spacers
Locknut (1/2
inch)
1x
2x
2x
4x
4x
2x
4x
Attaching the Cable Guide Assembly
to the Brackets
Bolt (3/8 x 1 inch)
Flange nut (3/8 inch)
4x
4x
2
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement