RailKing 30-79431 Operating Aquarium Car Operator’s Manual

RailKing 30-79431 Operating Aquarium Car Operator’s Manual
Operating Aquarium Car / Action Car
Operating Aquarium Car / Action Car
To replace the rollers follow the instructions below:
1) Remove the 4 screws and carefully remove the body.
To replace the rollers follow the instructions below:
1) Remove the 4 screws and carefully remove the body.
Body Screws
Body Screws
2) Disconnect the 2-pin connector at the top of the car.
2) Disconnect the 2-pin connector at the top of the car.
2-pin connector
3) Carefully remove the film Strip.
2-pin connector
3) Carefully remove the film Strip.
film strip
4) Remove the old roller (keep the washer)
film strip
4) Remove the old roller (keep the washer)
gear end roller
NOTE:The rollers are different.
Only one fits over the gear.
gear end roller
NOTE:The rollers are different.
Only one fits over the gear.
non-gear end
roller
non-gear end
roller
5) Apply the new roller over the pin at the correct location.
6) Place the washer onto the pin and push it down.
7) Reassemble in reverse order.
**(When reassembling be sure that the roller pins go into the guides in the body.
You can line the pins up with the guides by looking through the portal windows
on the ends of the car.)
5) Apply the new roller over the pin at the correct location.
6) Place the washer onto the pin and push it down.
7) Reassemble in reverse order.
**(When reassembling be sure that the roller pins go into the guides in the body.
You can line the pins up with the guides by looking through the portal windows
on the ends of the car.)
New Roller
New Roller
washer
washer
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement