RIVA RE4100-OV-R40 Quick Installation Guide

Quick Installation Guide

This manual provides instructions for quick installation and basic configuration of your IP device.

1. Part names and positions

Please check names and positions of each part with the following image. *

V

IN

1 V

IN

2

Input Configuration

V

IN

3

Switch (PAL/NTSC)

V

IN

4 V

OUT

Reset Switch

* Models herein and their appearance are subject to change without any prior notice. i

Note

The video input configuration must be set before you turn on the device. Changing the setting after the device is turned on will not affect on the configuration unless you reboot the device.

NE41R4011-2013-A

1

2. Install the IP device

Install the blade to the rack chassis. To see the correct installation of blade, refer to the following image below. screw screw

Ejecting a blade

1. Unscrew the screws.

2. Grasp the insert/eject handle of the blade and push it down as shown in above figure.

3. Remove the blade from the rack chassis.

Inserting a blade

1. Make sure that the inject handle is in the outward position.

2. Insert the blade into the rack chassis.

3. Grasp the insert handle of the blade and pull it up.

4. Fasten the screws.

NE41R4011-2013-A

2

3. Set up network environment

Set up network environment

The default IP address of the device is 192.168.XXX.XXX. Users can identify the IP address of the device from converting the MAC address’s hexadecimal numbers, which is attached to the device. Be sure that the device and PC are on a same area network before running the installation. If the network segment was different between your PC and the device, change your PC’s settings as below.

IP address : 192.168.xxx.xxx

Subnet mask: 255.255.0.0

Generic IP Environment

In case of generic private network environment where IP address 192.168.XXX.XXX are used, users may view the live streaming images on a web page using the device’s default IP address:

1.

Convert the device’s MAC address to the IP address. Refer to the Hexadecimal-Decimal

Conversion Chart at the end of the manual.

(The MAC address of the device is attached on the side or bottom of the device.)

MAC address = 00-13-23-01-14-B1 → IP address = 192.168.20.177

Convert the last two set of hexadecimal numbers to decimal numbers.

2.

Start the Microsoft® Internet Explorer web browser and enter the IP address of the device.

Web streaming and device configurations are supported through ActiveX program.

When the ActiveX installation pop-up window appears, authorize and install the ActiveX setup.exe.

NE41R4011-2013-A

3

IPAdminTool

IPAdminTool is a management tool, which automatically scans all of the network products for users to perform administrative tasks, which includes network configurations, firmware update, device reboot, and device organizations.

To modify the device’s default IP address for customized network area;

1.

Find the device from the IPAdminTool’s list and highlight the device’s name.

2.

Right-click the mouse and select IP Address; IP Setup window appears.

Give new unique IP address in last two sets and mirror other information in other boxes

PC environment Info

3.

In the IP Setup’s window, information under Local Network information displays the user/PC’s network area information. Those information need to be incorporated to the IP

Address, Subnet Mask, Gateway, and DNS boxes, except the last 2 sets of IP Address, which are to be the unique numbers for the device. Refer to the image above for the setting

4.

Click Setup to complete the modification.

5.

Enter the user name and the password, and then select Login.

(The default username and password are: root and pass.)

NE41R4011-2013-A

4

NE41R4011-2013-A

5

4. View video on web page

Once the device’s proper IP address has been identified, type the URL in a web browser to access the camera. At first time access, installation window may pop up.

1.

When the browser asks to install the AxUMF software, click Install to proceed.

2.

When Setup installation pop-up window appears, click install to proceed with rest of installations. i

Note

Depending on system OS and Internet Explorer version, installation experience may differ from one another. Figures described above are from Windows 7, Internet

Explorer 9 environment.

NE41R4011-2013-A

6

5. SETUP page

To set up the device configuration:

1.

Click Setup on the upper left of the web page. The login page is displayed as below.

2.

Enter the user name and the password, and then select OK.

(The default username and password are: root and pass.)

6. Reboot

Perform the following procedures to reboot your device:

1.

2.

3.

While the device is in use, press and hold the Reset button.

Release the Reset button after 2 seconds.

Wait for the system to reboot.

!

Caution

Please do not hold for more than 2 seconds. Otherwise, the device may be switched to its Factory Default settings.

7

. Factory Default

Resetting the device back to the factory default will initialize all parameters including the IP address back to the factory defaults. To reset to the factory default:

While the device is in use, press and hold the reset button for about 10 seconds.

(LED blinks when the device is restored to factory default status.)

Wait for the system to reboot.

The factory default settings can be inferred as follows:

IP address: 192.168.xx.yy

Network mask: 255.255.0.0

Gateway:

User ID:

Password:

192.168.0.1 root pass

More Information

To learn more about using other features of your devices, refer to the manuals as “RIVA

Web Interface Manual Full HD Series” or “VCAsys Manual Full HD Series”, which is available on www.rivatech.de homepage.

NE41R4011-2013-A

7

8. Safe Mode

Your device will get restarted with safe mode when the device is not booted completely over times. files. The errors are mainly caused by these two factors: power source unplugged or damage occurred on firmware file during the system boot.

You will see the page indicating that your device is in safe mode like below.

Browse

Please follow the steps below when your device turns into Safe mode.

1.

Turn off the device, and turn it on again.

2.

Wait until the device completely reboots.

3.

Refresh the webpage to check out if the webpage is displayed in normal.

What if your device still remains at Safe mode after the above procedure?

It means that some parts of your firmware files on the device are damaged and are not available anymore.

Then, follow the steps below to recover the firmware file.

1.

Click Browse on the screen, and select the appropriate firmware file available.

2.

Click START to restore the firmware to the device.

3.

Check if the webpage appears normal. i

Note

There is another method to update firmware, which is using

IPAdminTool.

Please refer to ‘IPAdminTool User’s Manual.pdf’ for the detailed procedure. i

If your device is still at safe mode after trying to update firmware, please contact your local agency to get further assistance.

Note

NE41R4011-2013-A

8

Hexadecimal-Decimal Conversion

Table

Refer to the following table when you convert the MAC address of your device to IP address.

11 17

12 18

13 19

14 20

15 21

16 22

17 23

18 24

19 25

1A 26

1B 27

1C 28

1D 29

1E 30

1F 31

20 32

21 33

22 34

23 35

24 36

Hex Dec

00 0

01 1

02 2

03 3

04 4

05 5

06 6

07 7

08 8

09 9

0A 10

0B 11

0C 12

0D 13

0E 14

0F 15

10 16

Hex Dec

79 121

7A 122

7B 123

7C 124

7D 125

7E 126

7F 127

80 128

81 129

82 130

83 131

6F 111

70 112

71 113

72 114

73 115

74 116

75 117

76 118

77 119

78 120

84 132

85 133

86 134

87 135

88 136

89 137

8A 138

8B 139

8C 140

8D 141

8E 142

8F 143

90 144

91 145

92 146

93 147

Hex Dec

54 84

55 85

56 86

57 87

58 88

59 89

5A 90

5B 91

5C 92

5D 93

5E 94

4A 74

4B 75

4C 76

4D 77

4E 78

4F 79

50 80

51 81

52 82

53 83

5F 95

60 96

61 97

62 98

63 99

64 100

65 101

66 102

67 103

68 104

69 105

6A 106

6B 107

6C 108

6D 109

6E 110

Hex Dec

2F 47

30 48

31 49

32 50

33 51

34 52

35 53

36 54

37 55

38 56

39 57

25 37

26 38

27 39

28 40

29 41

2A 42

2B 43

2C 44

2D 45

2E 46

3A 58

3B 59

3C 60

3D 61

3E 62

3F 63

40 64

41 65

42 66

43 67

44 68

45 69

46 70

47 71

48 72

49 73

Hex Dec

C3 195

C4 196

C5 197

C6 198

C7 199

C8 200

C9 201

CA 202

CB 203

CC 204

CD 205

B9 185

BA 186

BB 187

BC 188

BD 189

BE 190

BF 191

C0 192

C1 193

C2 194

CE 206

CF 207

D0 208

D1 209

D2 210

D3 211

D4 212

D5 213

D6 214

D7 215

D8 216

D9 217

DA 218

DB 219

DC 220

DD 221

Hex Dec

A2 162

A3 163

A4 164

A5 165

A6 166

A7 167

A8 168

A9 169

AA 170

AB 171

AC 172

94 148

95 149

96 150

97 151

98 152

99 153

9A 154

9B 155

9C 156

9D 157

9E 158

9F 159

A0 160

A1 161

AD 173

AE 174

AF 175

B0 176

B1 177

B2 178

B3 179

B4 180

B5 181

B6 182

B7 183

B8 184

Hex Dec

E8 232

E9 233

EA 234

EB 235

EC 236

ED 237

EE 238

EF 239

F0 240

F1 241

F2 242

DE 222

DF 223

E0 224

E1 225

E2 226

E3 227

E4 228

E5 229

E6 230

E7 231

F3 243

F4 244

F5 245

F6 246

F7 247

F8 248

F9 249

FA 250

FB 251

FC 252

FD 253

FE 254

FF 255

NE41R4011-2013-A

9