920G-3

INSTALLATION INSTRUCTIONS

Step1: Drill Holes in Wall for screws or screw anchors

Determine your desired location for installation .Make a mark on the wall where each mounting screw will be placed as shown below. Making sure unit is level. Drill a hole on each mark.

2 3/8" ( 60.33

mm) 2.5" ( 63.50

mm) 2 3/8" ( 60.33

mm)

Step2: Attach unit to Mounting Surface.

DRILLED HOLE

ANCHOR

THREADED INSERT

SCREW

CARD-58 (CAP)

No portion of this document or any artwork contained herein should reproduced in any way without the written consent of ALLIED BRASS INC.