1020-3 INSTALLATION INSTRUCTIONS Step1: Drill Holes in Wall for screws or screw anchors Determine your desired location for installation .Make a mark on the wall where each mounting screw will be placed as shown below. Making sure unit is level. Drill a hole on each mark. 60.33 mm / 23 8 in 63.50 mm / 21 2 in 60.33 mm / 23 8 in Step2: Attach unit to Mounting Surface. DRILLED HOLE ANCHOR THREADED INSERT SCREW CARD-58(CAP) No portion of this document or any artwork contained herein should reproduced in any way without the written consent of ALLIED BRASS INC.
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project