Protectyte TRADPY0378, HDPY4X6, HDPY458, HDPY534, HDPY358 Installation guide

Protectyte TRADPY0378, HDPY4X6, HDPY458, HDPY534, HDPY358 Installation guide
Installation Guide for
Wood Pyramid and Traditional Pyramid Post Cap
Step #1: Apply Glue to Post
Place a generous amount of Liquid Nail or similar outdoor glue on
top of the Post in the shape of an “S”. Make sure it is thick
enough to spread out once you place the Post Cap on top of the Post.
Detail shown for
Step 42: Mount Post Cap to Post Traditional Pyramid.
Mount Wood Pyramid
in same fashion
Place the Post Gap on top of the Post where the glue >
has been applied. Move the cap around to completely `
spread the glue.
**DO NOT PUSH TOO HARD OR THE
GLUE WILL FLATTEN TOO MUCH
Make sure the Post Cap is sitting the way you
want on top of the Post.
FAQ
'Q: Can | screw the wood cap from the
top right into the post?
A: We do not recommend screwing the post
cap Into the post from the top. If you decide to
do this, pre-drill a hole to prevent cracking.
«--------
Q: Can | screw from the side of the wood
base into the post?
A: If you decide to do this, you should pre-drill
holes in the wood cap to avoid splitting.
Q: Can the wood caps be left alone or do they
need to be protected with some “sealer”?
A: Since the wood caps are Mahogany they
can be left alone to weather to a gray color. If
you want to preserve the “new” look then
choose a coating that gives you the protection
you desire. You can also paint or stain the
wood caps.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement