step 1. installing the brackets
inside mount
Pencil mark the mounting
screw holes at the top of b.
the bracket.
Drill holes at the pencil
marked locations.
Position the brackets near
each end of the head rail.
=]
Der
Pencil mark the mounting
screw holes at the back of
the bracket.
Drill holes at the pencil
marked locations.
2
Use level at top of brackets
to ensure siraight
alignment. Shade needs to
ATT
LU
Cordless Top-down/Bottom-up shade
Dear Customer:
The product you have purchased has been engineered and
manufactured to the highest standards of quality and performance.
To ensure proper installation, please read this instruction sheet carefully ©
before installing your new shade.
Metal measuring tape
Pencil
Phillips screwdrivers
Step ladder or stool
Drill & bits (1/8 ")
Level
e Secure the
brackets with
the mounting
screws
provided.
an
Secure the
brackels with the
mounting screws
‘provided.
When mounting
brackets on wall
board or plaster,
use the wall
be level for proper
operation.
* Insert the flange of the top rail onto
the top of the bracket as shown in
the drawing then snap-in the rear
part of the rail onto the tab of the
bracket in a twisting motion.
Note: I. Avoid placing brackets over the spring box or cord pulleys.
2. When installing brackefs make sure the brackets do not catch the shade cord(s) against the head rail.
anchors provided.
hardware contents
bracket operation handle
(AT) x 2 (A2) x 1
ocltom rail top rail
Tools needed for installation
mounting Screw wall Anchor
(1-1/8") (A5) x 4.
>
step 3. assembling the operation handle
e Locate ihe center of ® Rotate the handle ® Rotate the handle
each of the rails. side view upwards until it snaps downwards until it
Gently lift the shade
materic! out of the way.
Fasten the top of the
handie onto the middle
backsice of the top rail
depending on operation
handle.
info place. snaps into place.
step 4. operating the shade
To lowar shade To raise shade
===
FU Raising the headrail
| aising the headrail:
| : ‘
Lowering shade: Raising shade: al de at the Simply push up on the
Simply grasp the center of Simply grasp the center of неск 10 lowest io headrail to raise it to
the bottom rail and pull the bottom rail and push ed a i d desired position and
the shade down to desired it upward fo the desired desired position an release:
length and release. length and release. release.
cleaning your shade:
For best results, we suggest using vacuum cleaner or dry cloth fo remove dust.
For spot-removal try using light damp cloth to wipe the spot clean. Do not use
any kind of chemical to clean the shade as it may damage the shade.
= da
TEL
icomeind.com