Delaney BD3064 3000 Series 6 ft. Black Low Profile Top Mount Barn Door Hardware Kit Installation Guide
Advertisement
Advertisement
TOOLS REQUIRED
1/4”
BARN DOOR HARDWARE KIT
3000 SERIES ASSEMBLY INSTRUCTIONS
INCLUDED
COMPONENTS
Track (1)
Hanger (2)
Floor Guide (1)
Mounting Screw (4) 5/16 Lag Bolt (4 or 6)
#8 Floor Screw (2)
Left & Right Stops (2)
Wall Spacer (4 or 6) Anti-Jump Disc (2)
¼ Floor Anchor (2)
Allen Wrench (1)
1/4"
3/4"
1
PREPARE THE DOOR
If using the Floor Guide, mortise a groove ¼” wide by ¾” deep into the bottom center of door’s edge.
4"
2
INSTALL HANGERS
Position hangers on top of door, measuring 4” to center of outside hole.
Secure hangers using screwdriver.
* Optional Connector Plate available if connecting multiple tracks.
* Header Board and
Anchoring Screws not included in kit.
4a
3
INSTALL HEADER BOARD
Do NOT install track directly onto drywall. Install a 1 ” x 4 ” or 1 ” x 6 ” Header Board above the door opening directly into studs. Header board must be solid wood and measure at least the full legth of the track or longer.
4 4b
INSTALL STOPS & TRACK
4a.
Insert Stops on either side of track, inside the first & last hole.
4b.
Position center of the track by measuring up from the floor
(door height + 1 ¾”). Align Spacers with holes in track. Use Lag
Bolts to install track into wood header & wall. Use wrench to secure screws through spacers.
BARN DOOR HARDWARE KIT
3000 SERIES ASSEMBLY INSTRUCTIONS
For questions about installation, please visit
www.delaneyinc.com/barndoorinstructions.asp
Or call (800) 952-4430
5
INSTALLING THE ANTI-JUMP DISCS
Position each anti-jump disc at least 1” from the edge of the hangers. Tighten slightly to secure in place.
6
HANG THE DOOR
Place assembled door on secured track. Tighten the anti-jump discs. Slide door from open to close to ensure all parts are operating smoothly. Secure stops in desired positions with allen wrench.
1 3/16"
1/4"
7
INSTALLING FLOOR DOOR GUIDE (Optional)
Once the door is plumb, place the floor door guide inside the groove and line up close to the door opening. Slide the door from open to close to insure working order. Mark holes with a pencil. Pre-drill ¼” holes. If mounting into a concrete floor, use provided anchors.
COMPLETED DOOR WITH BARN DOOR KIT
** Note that these instructions are for use with Delaney
Hardware 3000 Series Barn Door Kits.

Public link updated
The public link to your chat has been updated.
Advertisement