Lanco PV357-5, PV357-4 User manual

Lanco PV357-5, PV357-4 User manual
Polyurethane Varnish™ PV-357
Rev. 06 / 2016
Method of Application:
DANGER / WARNING:
Apply by brush or roller, use Lanco® All Purpose Roller 3/8” Nap PA-566 or
conventional or airless spray. Roller application may require special care to
prevent bubbling and more than one coat to obtain proper thickness. Apply
at 4 mils wet film thickness that will yield 2 mils dry film thickness.
With a clean soft varnish brush apply a thin, smooth coat brushing in grain
direction. Maintain a wet edge and brush out any lap marks.
A second coat, if desired, may be applied without sanding as soon as first
coat is dry. If allowed to dry more than 12 hours, sand or buff with fine
sandpaper (#220) or steel wood to insure proper adhesion between coats.
Remove all dust before varnishing.
PRECAUTION: FLAMMABLE MIXTURE, DO NOT USE NEAR FIRE OR
FLAME.
CONTAINS: PETROLEUM DISTILLATES. USE ONLY WITH ADEQUATE
VENTILATION.
AVOID PROLONGED OR REPEATED BREATHING OF VAPOR.
It is important to use adequate ventilation as high vapor concentration may
cause unconsciousness or even asphyxiation. Ventilation must be sufficient
to limit exposure below MSDS limits. Eye irritation and dizziness are
indications of over exposure.
Equipment: Conventional Spray: For suction feed, use DeVilbiss MBC gun
with “E” tip and needle and 30 air cap or equivalent at 35-40 psi atomizing
pressure feed. For pressure feed, use DeVilbiss MBC gun with tip and needle
and 704 air cap or equivalent at 35-40 psi atomizing pressure and 5-8 psi
fluid pressure, 3/8” ID material hose, double regulated pressure tank with oil
and moisture separator.
Refer to LANCO MATERIAL SAFETY DATA SHEET.
PROVIDE ADEQUATE VENTILATION DURING APPLICATION AND
DRYING CYCLES. DO NOT TAKE INTERNALLY. Swallowing may cause
injury, illness or death. If swallowed, do not induce vomiting. Call a physician
immediately.
NOTICE: Reports have associated repeated and prolonged occupational
over exposure to solvents, with permanent brain and nervous system
Airless Spray: Minimum of 28:1 ratio pump, 0.011”-0.013” orifice tip 1/4” damage, peripheral nervous tissue damage and liver abnormalities.
Intentional misuse by deliberately concentrating and inhaling the contents
ID Teflon material hose.
may be harmful or fatal.
Limitation: Apply in good weather when air and surface temperature are ALWAYS WEAR RESPIRATORY PROTECTION (NIOSH, MSHA TC 23C OR
above 40ºF and surface temperature is at least 5ºF above the dew point. For EQUIVALENT). KEEP OUT OF REACH OF CHILDREN.
optimum application properties, material should be between 70º to 100ºF
prior to mixing and application.
Note: When multiple coats of product are applied, be sure to sand lightly
between coats with a fine sandpaper and dust clean or vacuum.
Cleanup: Wipe up drips and spatters with Lanco® Mineral Spirits MS-107.
Clean all equipment with this solution.
Caution: Do not take internally. Close container after each use. Keep out of
the reach of children. Combustible; keep away from heat and open flame.
Avoid prolonged contact with skin and breathing vapors or spray mist.
• NORTH AMERICA • 600 Mid Florida Drive Airport Industrial Park of Orlando, Florida 32824 • Tel. (407) 240-4000 Fax (407) 240-4046
• CARIBBEAN & SOUTH AMERICA • Urb. Aponte #5, San Lorenzo, Puerto Rico USA 00754 • Tel. (787) 736-4221 Fax (787) 736-5313
• CENTRAL AMERICA • Zona Industrial Bes, lote #4, El Coyol de Alajuela, Costa Rica • Tel. (506) 2438-2257 Fax (506) 2438-2162
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement