Noble House 296186 Installation guide

Noble House 296186 Installation guide
Caution : You must read this before you proceed
Remind: Umbrella open diameter max. 70 inches
Umbrella Base
Umbrella Base Weight : Appr. 55lbs
Page 1 OF 6
Label
Picture
Description
QTY
A
Umbrella Base
1
B
Support Pole
1
C
Adjustable Screw
1
D
Cap
1
E
Adapter For 38mm Parasol
Pole
1
F
Adapter For 48mm Parasol
Pole
1
G
Locking Bolt
1
H
Washer
1
I
Spanner
1
Page 2 OF 6
Before Beginning
Assembly:
WARNING : AVOID CHOKING / CHOKING HAZARDS : Do not allow children to play with
plastic wraps and / any small parts in this package.
Notice: As a safety precaution, when umbrella is not in use please turn down umbrella.
Remove Umbrella from this base and store in safe location
This base is NOT suited and NOT recommended to be used as a free-standing Umbrella
Base.
This base must be used under a matching table and matching Umbrella size.
ATTENTION : This Umbrella Base is exclusively recommended to be used together under
a table with the matching umbrella with diameter of 70inches to78inches.
The matching Support Pole diameter : 38mm - 48mm.
Page 3 OF 6
Parts Introduction
Cap(D)
Adapter For 38mm Parasol Pole(E)
Adapter For 48mm Parasol Pole(F)
Support Pole
Adjustable Screw(C)
Umbrella Base (A)
Washer(H)
Locking Bolt (G)
Spanner(I)
This UMBRELLA BASE has multiple parts and may require up to some 30 minutes to
assemble. To give you an overview of the UMBRELLA BASE parts, the above picture is to
help you put the various parts into perspective. Please read through the instructions
herebelow to familiarise the parts and steps before assembly.
Step 1
(H)
(B)
(G)
(I)
(A)
Page 4 OF 6
This is a 2-person team assembly product.
Tilt the Umbrellas Base to its side as pictured.
Place the Support Pole(B) through the Umbrella Base (A) and attach them using Locking
Bolt (G) and Washer(H) by Spanner ( I ).
Tighten all joints completely.
Turn over the Umbrella Base
Step 2
(B)
(C)
Screw Adjustable screw (C) into Support Pole (B).
Step 3 - A
(B)
For the Umbrella pole with diameter as 38mm, use Dia.38mm Adaper (E) & Dia.48mm
Adapter (F) added together, insert the Dia.48mm Adapter (F) into the Support Pole (B)
firstly, and then put the Dia.38mm Adapter (E) onto the dia.48mm Adapter (F).
Turn the Cap (D) onto the Support Pole (B) to hold the Adapters in place.
The Umbrella base is fully assembled and ready for use.
Step 3 - B
Page 5 OF 6
For the Umbrella pole with diameter as 48mm, use Dia.48mm Adapter (F) only, insert the
Dia.48mm Adapter (F) into the Support Pole (B).
Turn the Cap (D) onto the Support Pole (B) to hold the Adapters in place.
The Umbrella base is fully assembled and ready for use.
Caution: This Umbrella Base only be used on a flat, level surface.
Page 6 OF 6
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement