Noble House 300378 Installation guide

Noble House 300378 Installation guide
Caution : You must read this before you proceed
Umbrella Base
Reminder : Maximum diameter for open Umbrella - 86 inches
Picture
Label
Picture
Description
QTY
A
Umbrella Base
1
B
Support Pole
1
①
Bolt
1
Page 1 OF 5
②
Washer
1
③
Socket Wrench
1
④
38mm & 48mm
Adapter
1
Before
Beginning
Assembly:
WARNING: CHOKING HAZARD. Do not allow children to play with plastic wraps or any small parts in this package.
Notice: As a safety precaution, when your Umbrella is not in use, please close the Umbrella.
Remove Umbrella from this Base and store in safe location
This Base is NOT suited and NOT recommended to be used as a free-standing Umbrella Base.
This Base must be used under a matching table and matching Umbrella size.
ATTENTION: This Umbrella Base is exclusively recommended to be used together under a table with the matching
Umbrella with diameter of 71 inches to 80 inches.
The matching Support Pole diameter: 38mm - 48mm.
Page 2 OF 5
Overview
Support Pole(B)
Umbrella Base(A)
FRONT FACING
This Umbrella Base has multiple parts and may require up to 30 minutes to
assemble. To give you an overview of the Umbrella parts, the above picture
is to help you put the various parts into perspective. Please read through the
instructions below to familiarise yourself with the parts and steps before
assembly.
Step 1
This is a two person team assembly product.
Tilt the Umbrella Base to its side as pictured.
Attach Support Pole(B) and to Umbrella Base(A) using Bolt(①) and Washer(②) with Socket
Wrench(③).
Tighten Bolt until fully secure.
Page 3 OF 5
For Umbrella Pole with 48mm diameter:
Insert the 38mm & 48mm Adapter(④) into the Support Pole(B). Pull out the 38mm
Adapter; Then insert your 48mm Umbrella Pole. Tighten the Adjustable Screws on the
Support Pole securely in a sequential manner to your Umbrella Pole.
The Umbrella Base is ready for use.
This Umbrella Base only be used on a flat, level surface.
For Umbrella Pole with 38mm diameter:
Insert the 38mm & 48mm Adapter(④) into the Support Pole(B).
Then insert your 38mm Umbrella Pole. Tighten the Adjustable Screws on the Support
Pole securely in a sequential manner to your Umbrella Pole.
The Umbrella Base is ready for use.
This Umbrella Base only be used on a flat, level surface.
Page 4 OF 5
Page 5 OF 5
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement