Rust-Oleum | 300112 | User manual | Rust-Oleum 300112 User manual

TECHNICAL DATA
ROC-55
RUST-OLEUM®
RUST DISSOLVER GEL
.DESCRIPTION AND USES
.PRODUCT APPLICATION (cont.)
.
®
Rust-Oleum Rust Dissolver Gel clings to iron, steel and
other metals to make rust removal convenient, fast and
effective. Rust Dissolver Gel also inhibits the return of rust
and creates a suitable surface for painting.
DISSOLVING RUST FROM IRON OR STEEL: Turn
sprayer to “SPRAY” position and apply remover liberally to
surface. Continue to apply remover as needed keeping the
surface wet until the rust is dissolved. Chemical action
begins at once. Cleaning time will vary according to the
severity of the rust. Medium to light rust will be dissolved
in 10-30 minutes or less, while heavier deposits may
require a second application. Once the rust is dissolved,
rinse with water and wipe the surface dry. After one hour
or more, the surface is ready to be painted.
IMPORTANT: Always test on an inconspicuous area first.
For best results, apply in ambient temperature of 70°F or
above. On metal, maintain a wet solution on the surface to
remove rust. Once the rust is dissolved, rinse or wipe the
surface and wait one hour or more before painting. Do not
allow to dry on a painted surface. For improved paint
adhesion on clean metal surfaces, dilute remover 50/50
with water, apply the solution and rinse or wipe the surface
dry. To avoid flash rust, wipe the clean metal with a dry
cloth or place in a warm, dry atmosphere. Do not use on
marble.
.PRODUCTS
SKU
300112
ALUMINUM/CHROME: Apply the remover to a wet
surface. Allow time to dissolve the rust, then rinse away
with clean water and buff dry with a cloth.
GALVANIZED SURFACE: Where the surface is unbroken,
treat as suggested for aluminum. Where rust is showing at
the surface, treat as for iron or steel.
.
DANGER! Contains phosphoric acid. Causes burns to the
eyes and skin irritation. May be harmful if swallowed. Use
only with adequate ventilation. Avoid breathing vapors
or spray mist. Do not get in eyes. Wash thoroughly after
handling.
Description
1-Quart (32 ounce Trigger Spray)
.PRODUCT APPLICATION
.
.
DIRECTIONS FOR USE
FIRST AID: In case of contact with eyes or skin, flush
with water for at least 15 minutes. Remove contaminated
clothing. If swallowed, do not induce vomiting. Get medical
attention immediately. In case of spillage, absorb with inert
material and dispose of in accordance with applicable
regulations.
Remove oil and grease from the metal to be treated. On
heavily rusted surfaces, remove any loose rust particles
with a wire brush. Rinse the metal with water to break the
surface tension and wash away any loose dirt. Turn
sprayer to “SPRAY” and apply remover liberally to the
surface. Continue to apply the remover as needed,
keeping the surface wet until the rust is dissolved.
Disassemble units composed of moveable parts before
applying remover. Clean parts and allow to dry before
reassembling.
KEEP OUT OF REACH OF CHILDREN.
.PHYSICAL PROPERTIES
.
Physical Properties
Composition
RUST DISSOLVER GEL
Phosphoric Acid and Proprietary Ingredients
Per Gallon
9.9 lbs.
Per Liter
1.19 kg
Weight
pH (Concentrate)
1.0-2.0
VOC
0% wt.
Shelf Life
5 years
Flash Point
Safety Information
>200°F (93°C)
For additional information, see SDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 877-385-8155
www.rustoleum.com
Form: GDH-997
Rev: 051816

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project