Easy Planking 11337 1/4 in. x 5 in. x 2 ft. Mixed Color Reclaimed Smart Paneling 3D Barn Wood Wall Plank (Design 5) (12 – Case) Installation Guide

Easy Planking 11337 1/4 in. x 5 in. x 2 ft. Mixed Color Reclaimed Smart Paneling 3D Barn Wood Wall Plank (Design 5) (12 – Case) Installation Guide
INSTALLATION INSTRUCTION
1. Select orientation: horizontal, vertical
or diagonal.
2. Using a level, draw a line on the wall
for the Starter Plank.
3. Prepare the finishing nails: either
install the enclosed nail strip into the
nail gun for 1.25” # 18 gage brad nails,
or chip nails from the strip for
hummer installation.
4. Apply a whole length or pre-cut
starter plank to the line on the wall
and afix it with the nails in each
corner of the plank. Step at least 1 in.
from each side or end of the plank to
nail it. For long planks apply two more
nails in the middle of the board.
5. If you need to cut any planks, use any
wood saw (table saw or hand saw) or
cut the furrow in the wood with a
utility knife on both sides of the plank
and break it against the edge of the
table.
6. If you need to attach wall art or
shelves on top of the wall planks, drill
the holes and put hangers through
the planks on your wall. Don’t hang
anything heavier than 0.5 lbs on the
planks themselves!
7. Other installation options:
- Double sided sticky foam – we don’t
recommend using them alone (sooner or later
planks may fall down) if you don’t secure
planks with nails.
- Adhesive or liquid nails – recommended if you
use a contractor for professional installation.
The adhesive should be applied along the
length of the planks with three thin strips (not
as butter on brad distributed evenly (!)):
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement