American Standard 7545170.002 Monterrey 4 in. Centerset 2-Handle 1.5 GPM Gooseneck Bathroom Faucet with Limited Swivel Spout in Polished Chrome Installation Guide

American Standard 7545170.002 Monterrey 4 in. Centerset 2-Handle 1.5 GPM Gooseneck Bathroom Faucet with Limited Swivel Spout in Polished Chrome Installation Guide
Installation
Instructions
CENTERSET LAVATORY FAUCETS
WITH GOOSENECK SPOUT
7500
7501
7502
7545
Series
Series
Series
Series
Thank you for selecting American-Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.
1
CAUTION
Certified to comply with ANSI A112.18.1M
60185 Rev. 1.7 (11/15)
Turn off water at
main supply.
6
Asesemble GASKET (1) to SHANKS (2) and insert FAUCET SHANKS
through holes of SINK.
5
Assemble LOCKNUTS (3) from underside of SINK. Align BODY as far forward as possible
and secure position by tightening LOCKNUTS (3).
8
Connect the HOT water supply to the left SHANK and the COLD water supply to the right
SHANK using sealant, appropriate connectors, and COUPLING NUTS (4).
7
To change spout to a swivel spout: (7500, & 7502)
Unscrew SPOUT NUT (5) and remove SPOUT (6).
Take SPOUT CLIP (7) off SPOUT (6) and remove RUBBER RING (8).
9
Replace RUBBER RING (8) with seperate PLASTIC RING (9)
packed with faucet.
Put SPOUT CLIP (7) on SPOUT.
Reassemble SPOUT (6) to BODY.
2
1/2" O.D. SLIP
BODY
1
SINK
3
COLD
4
HOT
4
2
GRID DRAIN ASSEMBLY (Model 7502 only)
1
PUTTY
Apply a bead of PUTTY around underside of DRAIN PLUG FLANGE (1). Insert DRAIN PLUG (2)
into SINK drain hole.
Hold DRAIN PLUG (2) to prevent turning and assemble GASKET (3), WASHER (4) and LOCKNUT (5)
from underneath sink.
Insert threaded end of TAILPIECE (6) into lower end of DRAIN PLUG (2). Connect other end to trap.
SINK
2
3
4
5
2
3
TEST INSTALLED FAUCET
Remove AERATOR.
Operate LIFT ROD and check DRAIN for leaks.
With handle in OFF position, turn on water supplies and check
all connections for leaks.
Turn handles into OFF position and replace AERATOR.
Operate both handles to flush water lines thoroughly. Check
spout mounting and hose connections for leaks.
4
SERVICE
To change direction of handle rotation, proceed as follows:
Turn valve to OFF position.
Remove HANDLE and BONNET NUT.
Remove SPRING CLIP.
Lift STOP WASHER, turn 90° and replace.
Replace SPRING CLIP.
Replace BONNET NUT, HANDLE, SCREW, and INDEX.
AERATOR may accumulate dirt causing distorted and reduced water flow. Remove AERATOR and rinse clean.
If spout drips, operate handles several times from OFF to ON position. Do not force - handles turn only 90°.
Plastic SCREEN in CARTRIDGE may accumulate dirt causing reduced water flow. To clean, first
turn off hot and cold water supplies, then:
Remove HANDLE and BONNET NUT.
Remove CARTRIDGE by pulling up.
Thoroughly rinse plastic SCREEN at base of CARTRIDGE.
Replace CARTRIDGE until flange is tight against valve body.
Turn valves OFF.
Replace BONNET NUT, HANDLE, SCREWand INDEX.
90°
STOP
WASHER
SPRING
CLIP
CARTRIDGE
SCREEN
60185 Rev. 1.7 (11/15)
7500
7501
7502
7545
M919646-0020A
SPOUT
M922858-0020A
VR AERATOR,
0.35gpm
051322-0020A
VANDAL PROOF SCREW
066114 -0020A
VR AERATOR,
0.5gpm
GRID DRAIN
000690-0020A
HANDLE SCREW
051211-0070A
INDEX KIT
051214-0070A
SWIVEL/FIXED
SPOUT RINGS
015025-YYY0A
DRAIN COMPLETE
070532-0040A
TAILPIECE
Series
Series
Series
Series
M964478-0020A
6" WRIST BLADE
HANDLE KIT (7400.160)
051217-0020A
4" WRIST BLADE
HANDLE KIT
M923208-0070A
FLOW RESTRICTOR
(7500.180, 7500.188
7500.186)
000690-0020A
HANDLE SCREW
051211-0070A
INDEX KIT
M918014-0070A
ADAPTER
012087-0070A
SPOUT SEAL KIT
904939-0020A
BONNET NUT
051210-0020A
LEVER HANDLE
M918014-0070A
ADAPTER
951764-0070A
CARTRIDGE
FOR PRODUCTS SOLD BEFORE 1/1/16
066497-0020A
COMPLETE DRAIN BODY
911928-0070A
GASKET
066116-YYY0A
DRAIN STOPPER
POP-UP DRAIN
065800-0070A
LOCKNUT
028617-0020A
POP-UP ROD
024220-0070A
COUPLING NUT
066117-YYY0A
FLANGE KIT
065800-0070A
LOCKNUT
070847-0070A
CLIP
M964387-0020A
8" SPOUT
(7500.177)
066118-0070A
PIVOT ROD
0-RING
A919641-0020A
5" SPOUT
(7500.180)
900864-0070A
DRAIN BODY
M919246-0020A
6" SPOUT
(7500.186)
TAILPIECE INSERT
070532-0070A
TAILPIECE
M919658-0020A
8" SPOUT
(7500.188)
072574-0070A
EXTENSION ROD
HOT LINE FOR HELP
For toll-free information and answers to your questions, call:
1 (800) 442-1902
Mon. - Fri. 8:00 a.m. to 8:00 p.m. EST
Saturday 10:00 a.m. to 4:00 p.m. EST
60185 Rev. 1.7 (11/15)
Product names listed herein are
trademarks of AS America, Inc.
© AS America, Inc. 2015
IN CANADA 1-800-387-0369
(TORONTO 1-905-306-1093)
Weekdays 8:00 a.m. to 7:00 p.m. EST
IN MEXICO 01-800-839-1200
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement