GENERAL INSTALLATION INSTRUCTIONS
PREPARATION
Tools Required for Assembly: (Not included)
• Pencil
• Electrical drill
• 1/4” Masonry drill bit (for tile anchor)
INSTALLATION
Tiles
INSTRUCTIONS
• Phillips head screwdriver
• Tape measure
• Level
• Safety glasses
CAUTION : Tile anchors are for tile, granite, marble, cement surfaces only. Use drywall anchors for drywalls only.
1. Unscrew cap to reveal screw holes shown in Fig.1.
2. Hold the item up against desired position on wall, and mark the screw holes.
Use a measuring tape and a level for accuracy.
3. Remove the item and drill pilot holes into the tiles where the tile anchors
will be inserted using 1/4” Masonry drill bit.
4. Insert tile anchors into the hole.
5. Place the item over the tile anchors and place mounting kits in the order shown in Fig.2
.
Tighten screw, then tighten cap over the screw.
Fig. 1
Item being installed
Tiles
Item being installed
Fig. 2 Side View
Care and Maintenance
To maintain the beautiful luster finish, please use soft damp cloths when cleaning and never use any cleaning solvents.
The manufacturer reserves the right to, and do time to time, make changes and improvements in designs and dimensions.
Updated on August 19, 2014