Noble House Jamir 45 lbs. Concrete and Steel Patio Umbrella Base installation Guide
Advertisement
Advertisement
Caution : You must read this before you proceed
Umbrella Base
Reminder : Maximum diameter for open Umbrella - 80 inches
Label
A
B
①
②
Picture Description
Umbrella Base
Support Pole
QTY
1
1
Decorative Ring
Adapter for 38mm
Pole
1
1
Page 1 OF 5
③
Before
Beginning
Assembly:
Adapter for 48mm
Pole
1
WARNING: CHOKING HAZARD. Do not allow children to play with plastic wraps or any small parts in this package.
Notice: As a safety precaution, when your Umbrella is not in use, please close the Umbrella.
Remove Umbrella from this Base and store in safe location
This Base is NOT suited and NOT recommended to be used as a free-standing Umbrella Base.
This Base must be used under a matching table and matching Umbrella size.
ATTENTION: This Umbrella Base is exclusively recommended to be used together under a table with the matching Umbrella with diameter of 71 inches to 80 inches.
The matching Support Pole diameter: 38mm - 48mm.
Page 2 OF 5
Overview
Adapter for 38mm Pole(
③
)
Adapter for 48mm Pole(
④
)
Support Pole(B)
Umbrella Base (A)
FRONT FACING
This Umbrella Base has multiple parts and may require up to 30 minutes to assemble.
To give you an overview of the Umbrella parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 1
This is a two person team assembly product.
Place the Support Pole(B) through the Decorative Ring( ① ) and attach to Umbrella Base(A) as pictured above.
Tighten Support Pole until fully secure.
Page 3 OF 5
Step 2 - A
(B)
Used for Umbrella Pole with 38mm diameter.
Insert Adapter for 48mm Pole(F) into the Support Pole(B) first, then put the Adapter for 38mm Pole( ② ) into the
Adapter for 48mm Pole( ③ ).
Your Umbrella Base is ready for use.
This Umbrella Base only be used on a flat, level surface.
Step 2 - B
(B)
Used for Umbrella Pole with 48mm diameter.
Insert Adapter for 48mm Pole( ③ ) into the Support Pole(B).
Your Umbrella Base is ready for use.
This Umbrella Base only be used on a flat, level surface.
Page 4 OF 5
Page 5 OF 5

Download
Advertisement