Rust-Oleum Specialty 237706 0.6 oz. Gloss Almond Appliance Epoxy Touch-Up Paint (6-Pack) Use and Care Manual

Rust-Oleum Specialty 237706 0.6 oz. Gloss Almond Appliance Epoxy Touch-Up Paint (6-Pack) Use and Care Manual
TECHNICAL DATA
SPC-23
SPECIALTY
APPLIANCE TOUCH-UP PAINT
.DESCRIPTION AND USES
PRODUCT APPLICATION (CONT.)
.
Rust-Oleum® Specialty Appliance Touch-Up Paint is a
quick dry lacquer designed to provide a long-lasting, high
gloss finish on repairs to metal, porcelain, and appliances
such as stoves, refrigerators, washers, dryers and
dishwashers. This washable, moisture resistant finish is
designed for the exteriors of these surfaces. Do not use on
surfaces exposed to temperatures over 200°F (93°C) such
as stove tops. Not for use in sinks, tubs or other water
immersed surfaces.
.PRODUCTS
SKU (0.6 ounces)
203000
203001
203002
213174
SURFACE PRPERATION (cont.)
WARNING! If you scrape, sand or remove old paint, you
may release lead dust. LEAD IS TOXIC. EXPOSURE TO
LEAD DUST CAN CAUSE SERIOUS ILLNESS SUCH AS
BRAIN DAMAGE, ESPECIALLY IN CHILDREN.
PREGNANT WOMEN SHOULD ALSO AVOID
EXPOSURE. Wear a NIOSH-approved respirator to
control lead exposure. Clean up carefully with a HEPA
vacuum and a wet mop. Before you sand, find out how to
protect yourself and your family by contacting the National
Lead Information Hotline at 1-800-424-LEAD or log on to
www.epa.gov/lead.
.
_Description
White
Almond
Biscuit
Black
.PRODUCT APPLICATION
APPLICATION
Shake bottle to mix product. Unscrew the cap brush and
apply Appliance Touch-Up Epoxy using even strokes. For
deep scratches or chips, apply multiple layers allowing 10
minutes between coats. For best results, allow to dry
overnight before use. Do not use near open flame.
.
PAINTING CONDITIONS
DRY and RECOAT TIMES
Use when air and surface temperature is between 50-90°F
(10-32°C) and humidity is below 85% to ensure proper
drying. Do not apply to surfaces, when heated, exceed
200°F (93°C).
Based on 70ºF (21ºC) and 50% relative humidity. Allow
more time at cooler temperatures. Dries to the touch in 10
minutes, to handle in 30 minutes and is fully dry in 24
hours. Allow to dry 10 minutes between coats.
SURFACE PREPARATION
CLEAN-UP
Remove all dirt, grease, oil, salt and chemical
contaminants by washing the surface with soap and water.
Rinse with fresh water and allow to thoroughly dry.
Remove loose paint and rust with a wire brush or
sandpaper. Lightly sand glossy surfaces.
Clean up any excess product with lacquer thinner, rubbing
alcohol or acetone.
1
Form: GDH-343
Rev.: 070816
TECHNICAL DATA
SPECIALTY APPLIANCE TOUCH-UP PAINT
.PHYSICAL PROPERTIES
.
APPLIANCE TOUCH-UP PAINT
Resin Type
Acrylic Lacquer
Pigment Type
Varies with color
Solvents
Weight
Solids
Mineral Spirits, 2-Propanol, 1-Methoxy Acetate, Toluene
Per Gallon
8.2-9.3 lbs.
Per Liter
1.0-1.1 kg
By Weight
28.1-36.7%
By Volume
22.6-23.0%
Volatile Organic Compounds
<710 g/l (5.90 lbs./gal.)
Recommended Dry Film Thickness
(DFT) per Coat
2.0-4.0 mils
(50-100µ)
Wet Film to Achieve DFT (unthinned
material)
9.0-18.0 mils
(225-450µ)
Practical Coverage at Recommended
DFT (assumes 15% material loss)
0.25-0.5 sq.ft./bottle (0.6 ounces)
Dry Times at 70-80°F
(21°-27C) and 50%
Relative Humidity
Touch
10 minutes
Handle
30 minutes
Recoat
Allow 10 minutes between coats
Dry Heat Resistance
200°F (93°C)
Shelf Life
3 years
Flash Point
57°F (14°C)
Safety Information
For additional information, see SDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
An RPM Company
Phone: 877•385•8155
www.rustoleum.com
Form: GDH-343
Rev.: 070816
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement