Ambient Technologies RC-RB Remote-Control Extender Installation Manual

Thank you for your purchase.

If you need assistance with this item

Please call WholesaleNow at 877-669-4669.

Dip Switch Locations

The following is the procedure for allowing units to communicate when the number of Dip switches are not the same in the Remote and Receiver. WholesaleNow.com

3-6 match Receiver unit with four Dip switches

7off

8on ( only older units have 8 switches.)

Typical DIP Switch configuration for remotes with 7 DIP Switches and Receiver with 4 Dip Switches.

Remotes with 8 dip switches :

Use the same configuration as the 7 switch models and set switch 8 to

ON (up).

WholesaleNow.com

remote and receiver are set the same.

:

The dip switch positions need to match. Confirm the switches on the

Wire Harness Information

The wire harness on this unit may have a different connector than older units and you will need to replace it with the supplied wire harness.

Both wires on the new harness are black, older units may WholesaleNow.com

I

t doesn't matter which wire connects to which terminal.

.

Connect the two (2) 1/4" female connectors to the TP/TH and TH terminals on the control valve.

If you cannot get this unit to work with your remote please call us at 877-669-4669 and we will be happy to assist you.