Sennheiser Consumer Audio e835 S User guide

Sennheiser Consumer Audio e835 S User guide
e 835
Instruction manual
Stage Microphones
A
e 835
e 835 S
B
C
1
3
2
5-10 cm
>10 cm
D
30°
0°
60°
90°
0
5
10
15
20
25
dB
0°
30°
60°
90°
150°
180°
180°
50
0
120°
20
0
120°
125 Hz
250 Hz
500 Hz
1,000 Hz
2,000 Hz
4,000 Hz
8,000 Hz
16,000 Hz
150°
dBV
-40
-50
-60
-70
-80
Hz
20
,0
00
5,
00
0
2,
00
0
10
,0
00
0°, 1 m
1,
00
0
10
0
50
-90
Important safety information
• Please read this instruction manual carefully and completely before using the product.
• Make this instruction manual easily accessible to all users at all
times.
• Always include this instruction manual when passing the product
on to third parties.
Before operation
• Never open the housing of the product. If products are opened by
customers in breach of this instruction, the warranty becomes null
and void.
• Only use attachments, accessories or spare parts specified by
Sennheiser.
During operation
• Liquids entering the product can short-circuit the electronics or
damage the mechanics. Keep all liquids away from the product.
• Solvents or cleansing agents can damage the surface of the
product. Only use a soft, slightly damp cloth to clean the product.
• Do not expose the product to extreme temperatures.
After operation
• Handle the product with care and store it in a clean, dust-free
environment.
Intended use
Intended use includes:
• having read this instruction manual, especially the chapter
“Important safety information”,
• using the product within the operating conditions and limitations
described in this instruction manual.
“Improper use” means using the product other than as described in
this instruction manual, or under operating conditions which differ
from those described herein.
1
The e 835
The e 835 is a cardioid lead vocal stage microphone specially designed
to perform under pressure.
Cardioid is the most commonly used pick-up pattern for live PA
applications. It provides good on-stage freedom and also picks up
sound from the sides. The “dead” side is at the rear. This pattern is
good for picking up several vocalists at once, e.g. a choir or ensemble.
The e 835’s balanced frequency response maintains signal quality
when moving on and off axis during performance. The gentle presence
boost ensures vocal clarity and projection. The minimal proximity
effect provides for consistently clear bass-end performance when singing closer to, or further from the microphone.
The cardioid pick-up pattern provides excellent feedback rejection,
enabling the microphone to handle higher sound pressure levels. The
rugged metal construction and internal damping isolates handling
noise.
The e 835 S variant features a silent on/off switch.
Features
• Dynamic cardioid microphone for speech and vocals
• Clear reproduction with a high presence
• Consistent sound quality at varying distances or when off axis
• High sound pressure handling capability
• Optional silent on/off switch
• Shock-mounted capsule provides excellent suppression of handling
noise
• Excellent feedback rejection
• Humbucking coil
• Rugged metal body
Package contents
1
1
1
1
e 835 / e 835 S microphone
MZQ 800 microphone clamp
pouch
instruction manual
Product overview A*
1
2
3
4
*
Sound inlet basket
XLR-3 connector
On/off switch (e 835 S only)
Screw (e 835 S only)
Diagrams can be found on the cover pages.
2
Using the microphone
Switching the e 835 S on/off
XX
XX
Use the on/off switch to switch the the e 835 S on or off.
If necessary, use the screw 4 to lock the on/off switch 3 in the
“on” position.
Positioning the microphone C
Pos.
Resulting sound
Commentary
C.1
• High proximity effect
(large bass boost)
• Powerful, direct sound
Very little crosstalk
from other sound
sources
C.2
• Less proximity effect
(less bass boost)
More crosstalk from
other sound sources
• Some room ambience,
natural, balanced sound
C.3
• Very little proximity effect
(minimal bass boost)
Higher crosstalk from
other sound sources
• More room ambience,
indirect sound
If sibilance occurs:
XX
Position the microphone slightly to the side and not directly in front
of the mouth.
Positioning the monitor loudspeakers B
XX
To prevent feedback and crosstalk, postion your monitor loudspeakers in the angle area of the highest cancellation of the microphone
(approx. 180°).
Cleaning and maintaining the e 835
Caution
Liquids can damage the electronics of the product!
Liquids entering the housing of the product can cause
a short-circuit and damage the electronics.
XX
Keep all liquids away from the product.
XX
Do not use any solvents or cleansing agents.
XX
Unscrew the sound inlet basket 1.
XX
Remove the foam insert from the sound inlet basket 1.
Use a slightly damp cloth to clean the sound inlet basket 1 from
the inside and ouside.
XX Reinsert the foam insert into the sound inlet basket 1 and replace
the sound inlet basket on the microphone and screw it tight.
XX
3
Specifications
Transducer principle
dynamic
Frequency response
40 … 16,000 Hz
Pick-up pattern
cardioid
Sensitivity
(free field, no load at 1 kHz)
2.7 mV/Pa
Nominal impedance (at 1 kHz)
approx. 350 Ω
Min. terminating impedance
1 kΩ
Connector
XLR-3
Temperature range
0°C to +40°C
Dimensions
Ø 48 x L 180 mm
Weight
330 g
The polar diagram and the frequency response curve D can be found on
the cover pages.
Connector assignment
+
+
2
1
1
2
XLR
+
+
2
1
3
3
XLR
XLR
3
+
2
1
3
+
6.3 mm
XLR
+
2
1
3
XLR
4
+
balanced
6.3 mm
Manufacturer Declarations
Warranty
Sennheiser electronic GmbH & Co. KG gives a warranty of 24 months
on this product.
For the current warranty conditions, please visit our website at
www.sennheiser.com or contact your Sennheiser partner.
FOR AUSTRALIA ONLY
Sennheiser goods come with guarantees that cannot be excluded
under the Australian Consumer Law. You are entitled to a replacement
or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the
goods repaired or replaced if the goods fail to be of acceptable quality
and the failure does not amount to a major failure.
This warranty is in addition to other rights or remedies under law.
Nothing in this warranty excludes, limits or modifies any liability of
Sennheiser which is imposed by law, or limits or modifies any remedy
available to the consumer which is granted by law.
To make a claim under this warranty, contact
Sennheiser Australia Pty Ltd, Unit 3, 31 Gibbes Street Chatswood NSW
2067, AUSTRALIA.
Phone: (02) 9910 6700, email: [email protected]
All expenses of claiming the warranty will be borne by the person
making the claim.
The Sennheiser International Warranty is provided by Sennheiser
Australia Pty Ltd (ABN 68 165 388 312), Unit 3, 31 Gibbes Street
Chatswood NSW 2067 Australia.
In compliance with the following requirements
• WEEE Directive (2012/19/EU)
Please dispose of this product at the end of its operational lifetime
by taking it to your local collection point or recycling center for such
equipment.
CE Declaration of Conformity
• RoHS Directive (2011/65/EU)
• EMC Directive (2004/108/EC)
The declaration is available at www.sennheiser.com
5
e
e
e
e
e
e
e
e
4
86
84
83
61
5
5
5
4
9
II
sil
ve
2-
8
60
60
60
60
r
e
e
e
e
e
e
e
e
e
96
5
5
4
8
6
4
2
5
94
93
91
90
90
90
90
90
1
Sennheiser electronic GmbH & Co. KG
Am Labor 1, 30900 Wedemark, Germany
www.sennheiser.com
Publ. 08/15, 511655/A02
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement