Crux CCH-01W Vehicle Backup Camera User Manual

Crux CCH-01W Vehicle Backup Camera User Manual
Jeep
2007 – Up
-
Wrangler
Installs on your Wrangler's license plate bracket, keeping the rugged appeal of your Jeep.
120° wide viewing angle.
0.4 Lux minimum for night driving.
CCH-01W Camera Assembly
1.
2.
3.
4.
5.
6.
7.
8.
19 ½ ft. Video Extension Cable
Remove the stock license plate light at the back of the vehicle.
Install the camera assembly to where the stock license plate light was.
Connect the built-in license plate light of the camera to the stock license plate power connection.
Connect the power of the camera to your brake light wires:
Red wire to +12V
Black wire to Ground
Connect the video cable of the camera to the extension cord provided.
Run the video extension cable to the back of the radio.
Connect the video cable to your in-dash aftermarket multimedia or navigation receiver's camera input.
Put the gear in reverse to see the image from the camera.
Sensor
Viewing Angle (H)
Viewing Angle (V)
TV System
Guide Lines
CCD
170
90
NTSC / PAL
Yes
Invert Image
Resolution
Illumination
Power Supply
Waterproof
No
480 TV Lines
0.4 Lux / F1.2
12 Volts
IP67
042215
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement