Sony WH1000XM3/B User guide

Sony WH1000XM3/B User guide
Set the headset to “Priority on stable connection” mode. For details, see “About the sound
quality mode”.
Remove any obstacles between the antenna of the connecting Bluetooth device and the
built-in antenna of the headset. The antenna of the headset is built into the part shown in
the dotted line below.
A: Location of the built-in antenna
Bluetooth communications may be disabled, or noise or audio dropout may occur under
the following conditions.
o When there is a human body between the headset and the Bluetooth device
Put the Bluetooth device in the same direction as the antenna of the headset to
improve the Bluetooth communications.
o There is an obstacle, such as metal or a wall, between the headset and the
Bluetooth device.
o In places with wireless LAN, where a microwave oven is used, electromagnetic
waves are generated, etc.
The situation may be improved by changing the wireless playback quality settings or
fixing the wireless playback mode to SBC on the transmitting device. For details, refer to
the operating instructions supplied with the transmitting device.
Because Bluetooth devices and Wi-Fi (IEEE802.11b/g/n) use the same frequency (2.4
GHz), microwave interference may occur and result in noise, audio dropouts, or
communications being disabled if this headset is used near a Wi-Fi device. In such a case,
perform the following steps.
o Use this headset at least 10 m (30 feet) away from the Wi-Fi device.
o If this headset is used within 10 m (30 feet) of a Wi-Fi device, turn off the Wi-Fi
o Use this headset and the Bluetooth device as near to each other as possible.
If you are listening to music with your smartphone, the situation may be improved by
shutting down unnecessary apps or restarting your smartphone.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF