Antennas Direct Flex Installation guide

Antennas Direct Flex Installation guide
Helpful Tips:
When using the USB port on your TV, the in-line amplifier
will only draw power when the TV is turned on, eliminating power consumption. If you do not have a USB port on
the back of your TV, use the provided USB power adapter
with any standard AC wall outlet.
1. Connect one end of the Coaxial Cable (3) to the antenna (1) and then connect the other end of the
Coaxial Cable (3) from the antenna to the “TO ANT” connector on the In-Line Amplifier (4).
2. Connect the provided 3 ft. Coaxial Cable (5) to the In-Line Amplifier (4) connector labeled “TO TV”,
and connect the opposite end into the “Antenna Input” on your TV/converter box.
3. Connect the USB Cable (7) to the In-Line Amplifier (4). You have the option to connect the cable
into a USB port on your TV for power, or use the USB Power Adapter (6) and then plug the adapter
into a power outlet. Verify the blue LED light is on.
4. Perform a channel scan on your TV/converter box.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement