August Home AK-R1 Deadbolt Installation Manual

August Home AK-R1 Deadbolt Installation Manual
August Smart Keypad
Installation Guide
Inside the Box
August Smart Keypad
Mounting Plate
Two (2) 3/4” Screws
Two (2) Anchors
What you need
Drill w/ drill bit set
Hammer
Ballpoint Pen
Phillips Screwdriver
Level
1
1. Determine your drill bit size
2. Remove the keypad’s back panel
Depress the tab on the back of the keypad to remove the back panel.
2
3. Mark holes in wall for drilling
Use your level to position the back panel on the wall. Take your ballpoint pen or one
of the included screws and poke it firmly through the center of each of the two
rubber feet. Then mark the holes. Do not drill through the rubber feet.
4. Drill the holes
Use the drill bit size and type indicated in the drill bit chart. Drill holes in the two
spots you marked with your pen.
3
5. Add adhesive to the back of the keypad
Peel off one side of the adhesive covering. Carefully place the adhesive on the rear
side of the back panel.
6. Attach back panel to the wall
Firmly affix the back panel to the wall using the adhesive. Then take the two screws
and screw them into the wall through the holes you created in the back panel.
4
7. Attach keypad to the back panel
Remove the battery tab from the inside of the keypad. Hook the top of the keypad
onto the top of the back panel, rocking it down to the bottom until you hear a click.
8. Set up keypad with the August app
In the August app, go to the lock settings screen, select “Add a Smart Keypad,” and
follow the instructions.
5
Help
Call 844-AUGUST1 (284-8781)
or visit: august.com/support for answers.
01.18-R1
6
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement