SMARTSTANDARD Barn Door Hardware Kit Sliding Door Hardware User Manual
PDF
Download
Document
Advertisement
Advertisement
a a d d m mProduct n n Content ta ta SS TM 1.1, 1 x Rail rt rd a 2 x Hanger a 2.1, m nd ta SS rt a m TM d ar d n a SSt 3.1, 6 x Wall Spacer TM 3.2, 6 x Anchor SS TM rt rBoltd a 2.2, a 4 x Long Door m nd ta SS a m TM rt d ar d n a SSt TM t t d d r r r r a a a a 6 x Lag Bolt d stud) m nd m3.3, (For wood n ta ta (For concrete wall) SS TM 4.1, 2 x Door Stopper rt ard a d End m4.3, 2 xnRubber 4.4,t1ax Floor Guide 4.2, 1 x Hex Key SS TM SS TM t ar dard m n ta SS TM t t ar dard ar dard m 1, Penciln m n ta ta 2, Phillips Screwdriver Tools Needed SS TM 3, Wrench t a4, rPlumbdBobard m 5, Leveln a 6, tDrill SS rt TM d SS TM t rd ar 7, Tape a m 8, nDrilldBit ta9, Drill Bit SS rt a a d d m n n Measurements a t ta A 96” m TM d SS TM rt 16” B a d10”ard m n D ta SS rt a m TM 1/” 3/” d ar d n a SSt A B C D E F G E ⁄” TM Instructions t ar dard m n ta SS TM t ar dard m n ta SS 16” 16” SSta 16” t ar dard m n ta SS rt a m TM H F G d ar d n a SSt t r a dard m n ta SS TM t ar dard m n ta rt TM d SS t ar dard m n ta SS TM TM a m TM 2 d ar d n a SSt TM t r a dard m n ta SS TM rt SS TM TM t ar da m n ta SS t ar dard m n ta A Concrete wall Installation. TM TM t ar da m n ta Install the anchor to holes on the concrete wall first, then install carriage bolt to anchor. SS TM t r a dard m n ta SS TM SS TM t r a m nda ta SS TM Install the lag bolt to wood stud or head board directly. t ar dard m n ta SS TM t ar da m n ta SS TM t t t d r r ar dardInsert door stoppers a ar intodrail. a Install door stoppers d m n 3 between A-Bmand C-D.nDoorastopper mto prevent is used n the hangers coming ta taout of the rail. ta SS SS * Header Board and Lag Bolts for installing Header Board are not included in kit. TM d t ar dard m n ta B Drywall Installation. t ar dard m n ta SS SSta We provide 2 kinds of screws for you to install rail onto concrete wall or drywall. TMA B t t d r r rd a ar dH+1/” a a m nd m n ta ta SS SSta Level can make the rail horizontal. rt a d n m Place the rail against the wall, and use a pencil to mark where the holes should be. TM Make sure the height of holes on the wall is H+1/”. t ar dard m n ta SS H+1/” a d n m 1 C 1/” It is very important to determine whether you will be installing a Header Board prior to installing the track. Due to many overlapping factors such as the location of wall studs (Our rail come with pre-drilled holes every 16” on center), the weight of a barn door and the various types of trim used in M homes,Twe recommend using a HeaderTMBoard in all situations. Please install a 1” x 4” or 1” x 6” Header Board above the door opening directly into studs. Header Board must be solid wood and measure at least the full length of the track or longer. t ar dard m n ta SS 16” TM Overall Rail length is 96”. TM TM The gap between each pre-drilled hole is 16”. Distance from door top side to holes on the wall is 1/”. End of the rail is 10” away from the entrance of the door. Distance from the bottom of the door to the floor is ⁄”. Door height is H. The height of holes on the wall is H+1/”. t r a dard m n ta SS SS a d n m rt TM d SS TM t ar dard m n ta Do not screw it in place at this stage SS rt TM d SS C D TM t ar da m n ta SS rt TM a d n m SS4 ta t ar dard m n /” ta SS TM t ar dard m n ta SS5 TM rt a m rt m m SSta d ar TM 1/” 3/” d r a d n a t SS t ar dard m n ta SS TM /” t ar dard m n ta SS TM Install the hangers onto the door according to the measurements in the pictures below. Maximum door thickness is 1/”. If your door’s thickness is less than 1/”, please add some bolt washers or cut the long door bolts to a suitable length to fit the door. nd SSta a a d n m TM rt a m d ar d n a SSt TM t ar dard m n ta SS TM a a SSta a d n m SS TM rt TM d ta S /” S TM t ar dard m n ta SS rt TM d TM TM t ar dard m n ta SS TM SS TM t ar dard m n ta SS TM t ar dard m n ta SS a d n m TM SSta 10 TM t ar dard m n ta SS TM t ar dard m n ta SS SS TM Turn the rubber ends approximately 180 degrees so TM t ar dard m n ta SS TM SS TM t ar dard m n ta SS TM SS a d n m a d n m SSta SSta Install the floor guide. Put floor guide on the floor first to fix a suitable position and make a mark so that the M tip of the floor guide can Twork well in the slot. Use drill bit to drill holes on the floor where the mark is and then install the floor guide. and the rail. t8 thatrdthey are stuck between t the door t d r r r r a da a da a dard m n m n m n ta ta ta to drill holes on the door top side, please drill the holes /” away from the edge of the door. Then install the rubber ends on the door. t ar dard m n ta SS a d n a d n t ar dard m n ta rubber ends are used to protect the door from 6 rt The touching rt the door.rdYou need rdthe rail when sliding m a d m n ta7 Hang the door over thetarail SS Use router or circular saw to create a kerf at bottom of the door, along the center to allow the tip of the TM TM T-shaped floor guide to fit in between, to keep your door stable and prevent the door bottom swinging back and forth when you slide it open and closed. TM t ar dard m n ta SS TM t ar dard m n a t 1” SS TM t r a dard m n ta SS TM TM t ar da m n ta SS TM t ar da m n ta SS TM t r a m nda ta SS TM t t t rd rd Door ar daSliding ar daHardware ar da m n m n m n a a a t t t Manual (J Shape 8.0ft) SS SS TM SS TM TM Email: [email protected] the 2 door stoppers find adsuitable position, t t t thetodoor t t9 Adjust d d r r r r r r Use the hex key to screw stoppers in place. a da ar da a da ar dard a da m n m n m n m n m n ta ta ta ta ta SS TM t ar dard m n ta SS rt TM d SS TM t ar dard m n ta SS rt TM d SS TM t ar dard m n ta SS rt TM d SS SS TM TM t t d r r a ar dmart m nda m n a ta tandard ta S SS S SS TM TM rt d rt TM ">

Public link updated
The public link to your chat has been updated.
Advertisement
Related

SMARTSTANDARD SMARTSTANDARD 5ft Heavy Duty Sturdy Sliding Barn Door Hardware Kit -Smoothly and Quietly -Easy to Install -Includes Step-by-Step Installation Instruction Fit 30" Wide Door Panel ( J Shape Hanger) Sliding Door Hardware User Manual

SMARTSTANDARD 5FT Sliding Barn Door Hardware Whole Kit (Include 5ft Track Kit & Pull Handle Set & Floor Guide), Super Smoothly and Quietly User Manual
