USE
* Before first use, the battery must be
charged for at least 24 hours.
* Plug the appliance into the charger
whenever power gets low.
CHARGING THE BATTERY (FIG. D)
Л WARNI NG . Charge only at
ambient temperatures between 50°F (10°C)
and 104°F (40°C). The charger supplied with
this product is intended to be plugged In
such that it Is correctly oriented in a vertical
or floor mount position.
TO CHARGE THE APPLIANCE:
- Make sure the appliance Is switched off.
The battery will not be charged with the on/
off On/Off switch (1) in the On position.
* Plug the charging base (11) into a
standard 120 Volt 60 Hz electrical outlet.
- Lower the appliance onto the charging base.
The blue LED (3) in the base of the appliance
Will blink to indicate that it Is charging.
* When charging is complete, the LED will
turn off.
- The charger may become warm during
charging. This is normal and does not
indicate a problem.
While it Is safe to leave the appliance
connected to the charger indefinitely, to
reduce power consumption, we recommend
unplugging the charger after 24 hours.
Troubleshooting
Problem Possible Cause
* Unit will not start. + Battery not charged.
* Battery will not charge. + Charger not plugged in.
- Surrounding air
temperature too hot or
too cold.
Possible Solution
* Check battery charging
requirements.
* Plug charger into a working
outlet. Refer to “Important
Charging Notes” for more details.
* Check current at receptacie by
plugging in a lamp or other appliance.
* Check to see if receptacle is
connected to a light switch which
turns power off when you turn out
the lights.
- Move charger and tool to a
surrounding air temperature
of above 40 degrees F(4.5°C) or
below 105 degrees F (+40.5°C).
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK+DECKER help line at
rrwr12800-544-6986.
">
