red lion OMD User manual

red lion OMD User manual
Bulletin No. P-TCU/OM-E
Drawing No. LP0263
Released 7/05
Tel +1 (717) 767-6511
Fax +1 (717) 764-0839
www.redlion.net
OUTPUT MODULES
SPECIFICATIONS & TYPICAL CONNECTIONS:
INSTALLING OUTPUT MODULES
To install an output module into the controller, remove the bezel
assembly from the case (see Removing Bezel Assembly in the appropriate
instruction manual). Locate the correct output module socket (OP1, AL1,
or AL2/OP2, see figure below or label on outside of case) and plug the
output module into the socket. No re-programming is required. If changing
an output module type, be sure the appropriate output interface wiring
changes are made. Re-install the bezel assembly when complete.
Relay:
Type: Form-C
Rating: 5 Amps @ 120/240 VAC or 28 VDC (resistive load), 1/8 HP @
120 VAC (inductive load).
Life Expectancy: 100,000 cycles at maximum load rating. (Decreasing
load and/or increasing cycle time, increases life expectancy).
Logic/SSR Drive: Can drive multiple SSR Power Units.
Type: Non-isolated switched DC, 12 VDC typical.
Drive: 45 mA max. (3 VDC min.)
Note: Reference the “Output Modules” section for the various output
configurations.
Triac:
Type: Isolated, Zero Crossing Detection
Rating:
Voltage: 120/240 VAC
Max. Load Current: 1 Amp @ 35°C
0.75 Amp @ 50°C
Min. Load Current: 10 mA max.
Offstate Leakage Current: 7mA max. @ 60 Hz
Operating Frequency: 20 to 500 Hz
Protection: Internal Transient Snubber, Fused
Red Lion Controls AP
Red Lion Controls
20 Willow Springs Circle
Red Lion Controls BV
Basicweg 11b
31, Kaki Bukit Road 3,
#06-04/05 TechLink
York PA 17402
NL - 3821 BR Amersfoort
Singapore 417818
Tel +1 (717) 767-6511
Tel +31 (0) 334 723 225
Tel +65 6744-6613
Fax +1 (717) 764-0839
Fax +31 (0) 334 893 793
Fax +65 6743-3360
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement