When using a spacer block, mount the spacer to the arm, and then mount the sensor to the spacer. Hardware for the spacer is included with the sensor kit.
DISTANCE FROM TOP OF DOOR
MOUNTING HEIGHT RANGE: 75”
–
98”
(measured from finished floor to sensor LED)
VERIFY THAT THE ARM DOES NOT INTERFERE WITH THE DOOR FRAME WHEN CLOSED mounting wire passage mounting
1 ⁄
8
”
5 ⁄
16
”
1 ⁄
8
”
LEFT
MOUNT
NOTES (READ PRIOR TO MOUNTING):
Survey both sides of door to determine appropriate mounting location (distance from pivot edge and distance from top of door), taking into account the frame clearance, finger guard, door arm, etc.
The mounting arm should be mounted as close to the top of the door and as close to the hinge of the door as possible.
.
.
e that the arms
MOUNTING INSTRUCTIONS
. Ensur opriate horizontal and vertical lines and then align om the top of the door
: Fold along appr ee (3) holes.* epeat for right sensor
Print settings must be set to “ACTUAL SIZE.”
STEP 1
STEP 2
:
Mark and drill thr
:
Flip template and r
STEP 3
1”
Verify dimensions after printing.
1”
Reference LZR-microscan Mounting Template 75.5754 for full mounting instructions microscan
75.5908.01 LZR-MICROSCAN MOUNTING ARM MOUNTING TEMPLATE 20171113
When using a spacer block, mount the spacer to the arm, and then mount the sensor to the spacer. Hardware for the spacer is included with the sensor kit.
DISTANCE FROM TOP OF DOOR
MOUNTING HEIGHT RANGE: 75”
–
98”
(measured from finished floor to sensor LED)
STEP 1
STEP 2
STEP 3
: Fold along appr
:
Flip template and r
MOUNTING INSTRUCTIONS
with pivot edge and top of door
:
Mark and drill thr opriate horizontal and vertical lines and then align
RIGHT
MOUNT
1 ⁄
8
” mounting
NOTES (READ PRIOR TO MOUNTING): epeat for right sensor
.
Survey both sides of door to determine appropriate mounting location (distance from pivot edge and distance from top of door), taking into account the frame clearance, finger guard, door arm, etc.
5 ⁄
16
” wire passage
1 ⁄
8
” mounting
Print settings must be set to “ACTUAL SIZE.” om the top of the door
. Ensur e that the arms
The mounting arm should be mounted as close to the top of the door and as close to the hinge of the door as possible.
Verify dimensions after printing.
1”
.
1”
Reference LZR-microscan Mounting Template 75.5754 for full mounting instructions microscan
75.5908.01 LZR-MICROSCAN MOUNTING ARM MOUNTING TEMPLATE 20171113
