(197 AQUATIC Tub and Shower Repair Kit Contents of box: Gelcoat Putty, Hardener, Applicator stick, Sand рарег# 400 & #600 grit, Polishing compound and Alcohol wipe. Fiberglass Chip & Gouge Repair Made Easy! Enlarge chip or gouge Apply mixture to to a depth of at least | damaged area with 1/16” by sanding with _- wooden tool. Slightly the edge of a file, overfill crack to allow folded sand peer or for shrinkage. grinding tool. Remove all loose material. > Approximate working — time 15-20 minutes. Wait 1-3 hours or until material hardens. Start wet sanding with 400 rit moving to 600 grit make sure to kee sandpaper wet). The repair needs to be the same level as the surrounding area. 6 Make sure surroundin 2 area Is clean. Wipe wit alcohol cloth provided. | peo compound provided, hand polish to blend 3 Remove half a jar of Using the Gel-Paste (approx. 1/2 ounce) with wooden tool. PAT Add 4-6 drops of repaired area. Sit hardener. Mix together on back and enjoy a job a scrap of cardboard. If well done. temp. is over 80 F, lessen _ — amountof hardener. EEE 1 Kit Covers 1.5 SQ FT or 216 SQ IN NOTE: Temperature must be at least 60 F during entire process. This kit will repair any GEL-COAT tub, BUT MAY NOT MATCH ALL OFF —WHITES For Questions about this repair kit, CALL GCP @ 800-825-0747. www.gelcoatproducts.com
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project
advertisement
© 2021