Powering on/off and Settings: Light Controls Fan Controls > Lamp: Press the light display buttons to activate the light. Low, Medium, and High settings. To turn off, touch the light bulb icon. » Fan Controls: Press the fan display buttons to activate the fan. Low, Medium, and High settings. To turn off, touch the fan icon. [ CARE and MAINTENANCE ) Cleaning IMPORTANT: Clean the hood and panel filters frequently per the following instructions. Replace the panel filters before operating hood. Exterior Surfaces To avoid damage to the exterior surface, do not use steel wool or soap filled scouring pads. Always wipe dry to avoid water marks. Cleaning Method Use liquid mild-detergent soap and water, do not use hard abrasive cleaners. Wipe with damp soft cloth or non-abrasive sponge, then rinse with clean water and wipe dry. Do's: - Clean your range hood using a non-abrasive cloth or sponge and liquid detergent. - Always wipe in the direction of the grain pattern. - After cleaning rinse with water. * Make sure range hood is dry after cleaning. Don'ts: Do not use steel wool or like products as this will cause scratching and iron residue that could lead to rusting and corrosion. Do notwipe against the grain pattern as this will impact the original finish. ° Donotuse chlorine bleach. 21 Grease/Baffle Filter Remove the filter by pulling the spring release handle and then pulling down the filter. - Washfilters as needed in dishwasher or hot detergent solution (low temperature, short cycle). Ifyour model has a grease tray, please remove, drain and clean periodically. Make sure filters are completely dry before putting back into range hood. Reinstall the filter by making sure the spring release handles are toward the front. Insert filter into upper track. + Pushthe spring release handle. - Pushupon filter and release handle to latch into place. Replacing the LED light - Turnoffthe range hood and allow the light to cool.. ° To avoid damage or decreasing the life of the new bulb, do not touch bulb with bare fingers. Replace bulb wearing cotton gloves to handle bulb. If new light does not operate, make sure the lamps are inserted correctly before calling for support. To replace: 1. Disconnect the power cord to ensure unit does not turn on. 2. Remove filters. 3. Reach behind the light and push towards you until the light pops out. 4. Disconnectthe electrical harness. 5. Attach new bulbsto the electrical harness. 6. Snap bulbs back into unitand replace filters. 7. Reconnect the power cord. Electrical harness connection Filters * To replace the charcoal filter (non-ducted operation), remove the aluminum or baffle filters. * Turn the filter (attached to fan) counter clockwise to remove filter and clockwise to install new filter. ° Filter model number for these units: WRHF004S2 and HDRHF04592. 22
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project
advertisement
© 2021