GE GFD65GSPNSN 7.8-cu ft Stackable Steam Cycle Gas Dryer ENERGY STAR Installation instructions


Add to my manuals
4 Pages

advertisement

GE GFD65GSPNSN 7.8-cu ft Stackable Steam Cycle Gas Dryer ENERGY STAR Installation instructions | Manualzz

GFD65GSSN/GSPN

GE ® 7.8 cu. ft. Capacity Front Load Gas Dryer with Steam

DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)

GAS DRYER RATING

120V 60Hz, 8A

28

EXHAUST OPTIONS: 4-way via rear, left, right, and bottom.

CIRCUIT REQUIREMENTS: An individual, properly grounded branch circuit, protected by a

15-20 amp circuit breaker or a time-delay fuse, is required.

NOTE: Dryer wall outlet must be located within

36" of service cord entry and accessible when dryer is mounted in position.

INSTALLATION INFORMATION: For complete information, see installation instructions packed with your dryer.

32

39-3/4

6-1/8

3-5/8

For answers to your Monogram, GE Café ™ Series, GE Profile ™ Series or

GE Appliances product questions, visit our website at geappliances.com or call GE Answer Center ® Service, 800.626.2000.

Specification Created 9/19

GFD65GSSN/GSPN

GE ® 7.8 cu. ft. Capacity Front Load Gas Dryer with Steam

STACKED DIMENSIONS

(IN INCHES)

STACKED INSTALLATION:

Brackets for stacking dryer over washer are not included with the washer. Order part no. GFA28KITN.

ALCOVE OR CLOSET INSTALLATION:

If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back.

The dryer MUST be exhausted to the outside.

Minimum clearances between dryer cabinet and adjacent walls or other surfaces are: 0" all sides and top.*

Closet doors must be louvered or otherwise ventilated and must contain a minimum of 60 sq. in. of open area equally distributed. If this closet contains both a washer and a dryer, doors must contain a minimum of 120 sq. in. of open area equally distributed.

No other fuel-burning appliance shall be installed in the same closet with a gas dryer.

BATHROOM OR BEDROOM INSTALLATION:

The dryer MUST be exhausted to the outdoors.

The installation must conform with the local codes, or in the absence of local codes, with the National Electric Code and National Fuel Gas

Code, ANSI Z223 for gas dryers.

MINIMUM CLEARANCE OTHER THAN ALCOVE OR CLOSET

INSTALLATIONS:

Minimum clearances to combustible surfaces 0" all sides and top.*

FOR MORE INFORMATION ON VENTING KITS AND

ACCESSORIES,

PLEASE CALL 1-800-GE-CARES.

*For improved performance, a 1/2" clearance is suggested on each side.

54-1/2 "

PEDESTAL DIMENSIONS

(IN INCHES)

GFP1528PNDG - DIAMOND GRAY

GFP1528PNRS - SAPPHIRE BLUE

GFP1528PNSN - SATIN NICKEL

GFP1528SNWW - WHITE

This optional 16" pedestal raises the door opening and height of the washer or dryer.

16"

28"

79-1/2

28-7/8"

For answers to your Monogram, GE Café ™ Series, GE Profile ™ Series or

GE Appliances product questions, visit our website at geappliances.com or call GE Answer Center ® Service, 800.626.2000.

Specification Created 9/19

GE Dryer Vent

GE Dryer Vent

GFD65GSSN/GSPN

GE ® 7.8 cu. ft. Capacity Front Load Gas Dryer with Steam

DRYER EXHAUSTING INFORMATION – METAL DUCT ONLY

For complete information, see installation instructions packed with your dryer.

DUCTING MATERIALS: For best performance, this dryer should be vented with 4” diameter all rigid metal exhaust duct. If rigid metal duct cannot be used, then UL-listed flexible metal (semi-rigid) ducting can be used (Kit WX08X10077). In special installations, it may be necessary to connect the dryer to the house vent using a flexible metal (foiltype) duct. A UL-listed flexible metal (foil-type) duct may be used ONLY in installations where rigid metal or flexible metal (semi-rigid) ducting cannot be used AND where a 4” diameter can be maintained throughout the entire length of the transition duct. Please see installation instruction packed with your dryer for complete instructions when using flexible metal (foil type) ducting.

EXHAUST LENGTH CALCULATION:

1. Determine the number of 90° turns needed for your installation. If you exhaust to the side or bottom of dryer, add one turn.

2. The maximum length of 4" rigid (aluminum or galvanized) duct which can be tolerated is shown in the table.

A turn of 45° or less may be ignored. Two 45° turns within the duct length should be treated as a 90° elbow.

A turn over 45° should be treated as a 90° elbow.

Dryers must be exhausted to the outside.

CAUTION: For personal safety do not terminate exhaust into a chimney, under any enclosed house floor (crawl space), or into an attic, since the accumulated lint could create a fire hazard or moisture could cause damage. Never terminate the exhaust into a common duct or plenum with a kitchen exhaust, since the combination of lint and grease could create a fire hazard.

Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts, bird nesting, etc. The wall cap must also be located at least 12" above the ground or any other obstruction with the opening pointed down.

FOR MORE INFORMATION ON VENTING KITS AND ACCESSORIES, PLEASE

CALL 1-800-GE-CARES.

6-1/8

A

A

A

4

4

B

B

Domestic dryer models

2-1/2

2-1/2

7.5 cu. ft.

capacity models electric dryers

1-5/8

11

For answers to your Monogram, GE Café ™ Series, GE Profile ™ Series or

GE Appliances product questions, visit our website at geappliances.com or call GE Answer Center ® Service, 800.626.2000.

Best performance

Maximum length of 4" dia. rigid metal duct

Exhaust hood type

Number of

90° turns

0

1

2

3

4

A

4" opening

90 ft.

60 ft.

45 ft.

35 ft.

25 ft.

B

2-1/2" opening

60 ft.

45 ft.

35 ft.

25 ft.

15 ft.

3-5/8

Specification Created 9/19

GFD65GSSN/GSPN

GE ® 7.8 cu. ft. Capacity Front Load Gas Dryer with Steam

FEATURES AND BENEFITS

Powersteam – Refresh small loads and dewrinkle larger loads with the power of steam.

Built-in WiFi – Start, stop and monitor your laundry from anywhere while receiving real-time notifications and updates.

Quick Dry – Quickly dries items and small loads for families on the go.

Reduce Static – Helps remove static cling by spraying a gentle mist of steam near the end of the cycle.

Sanitize Cycle – Allows for a deeper clean with elevated temperatures designed to kill common household bacteria.

Wrinkle Care – Prevents wrinkles by extending the tumble without heat.

Damp Alert – Signals when delicate clothes reach the ideal dampness level for ironing or final air drying.

Vent Sensor – Provides alerts when a restriction is detected in your dryer vent.

4 Way Venting – Easy-to-change venting options provide the ultimate installation flexibility to fit in your home.

Model GFD65GSSNWW – White

Model GFD65GSPNSN – Satin Nickel

ADA

COMPLIANT

For answers to your Monogram, GE Café ™ Series, GE Profile ™ Series or

GE Appliances product questions, visit our website at geappliances.com or call GE Answer Center ® Service, 800.626.2000.

Specification Created 9/19

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Frequently Answers and Questions

What is the circuit requirement for GE GFD65GSSNWW?
It requires an individual, properly grounded branch circuit, protected by a 15-20 amp circuit breaker or a time-delay fuse.
What are the minimum clearances for alcove or closet installations?
0 inches on all sides and top.
What is the maximum length of 4" rigid metal duct that can be used for exhausting?
For domestic dryer models: 90 ft. with no 90° turns, 60 ft. with one 90° turn, 45 ft. with two 90° turns, 35 ft. with three 90° turns, 25 ft. with four 90° turns. For 7.5 cu. ft. capacity models and electric dryers: 60 ft. with no 90° turns, 45 ft. with one 90° turn, 35 ft. with two 90° turns, 25 ft. with three 90° turns, 15 ft. with four 90° turns.
What materials can be used for ducting?
4" diameter all rigid metal exhaust duct is recommended. If rigid metal duct cannot be used, UL-listed flexible metal (semi-rigid) ducting can be used. In special installations, a UL-listed flexible metal (foil-type) duct may be used.
What features does the GE GFD65GSSNWW have?
Powersteam, Built-in WiFi, Quick Dry, Reduce Static, Sanitize Cycle, Wrinkle Care, Damp Alert, Vent Sensor, and 4 Way Venting.

advertisement