GE GFD85GSPNDG 7.8-cu ft Stackable Steam Cycle Gas Dryer ENERGY STAR Dimensions Guide

Add to My manuals
4 Pages

advertisement

GE GFD85GSPNDG 7.8-cu ft Stackable Steam Cycle Gas Dryer ENERGY STAR Dimensions Guide | Manualzz

GFD85GSSN/GSPN

GE ® 7.8 cu. ft. Capacity Front Load Gas Dryer with Steam

DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)

GAS DRYER RATING

120V 60Hz, 6A 28

EXHAUST OPTIONS: 3-way via rear, left, and bottom.

CIRCUIT REQUIREMENTS: An individual, properly grounded branch circuit, protected by a

15-20 amp circuit breaker or a time-delay fuse, is required.

NOTE: Dryer wall outlet must be located within

36" of service cord entry and accessible when dryer is mounted in position.

INSTALLATION INFORMATION: For complete information, see installation instructions packed with your dryer.

32

39-3/4

6-1/8

3-5/8

For answers to your Monogram, GE Café ™ Series, GE Profile ™ Series or

GE Appliances product questions, visit our website at geappliances.com or call GE Answer Center ® Service, 800.626.2000.

Specification Created 9/19

GFD85GSSN/GSPN

GE ® 7.8 cu. ft. Capacity Front Load Gas Dryer with Steam

STACKED DIMENSIONS

(IN INCHES)

STACKED INSTALLATION:

Brackets for stacking dryer over washer are not included with the washer. Order part no. GEFLSTACK or part no. WE25X10018.

ALCOVE OR CLOSET INSTALLATION:

If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back.

The dryer MUST be exhausted to the outside.

Minimum clearances between dryer cabinet and adjacent walls or other surfaces are: 0" either side, 0" top, front and rear.

Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52".

Closet doors must be louvered or otherwise ventilated and must contain a minimum of 60 sq. in. of open area equally distributed. If this closet contains both a washer and a dryer, doors must contain a minimum of 120 sq. in. of open area equally distributed.

No other fuel-burning appliance shall be installed in the same closet with a gas dryer.

BATHROOM OR BEDROOM INSTALLATION:

The dryer MUST be exhausted to the outdoors.

The installation must conform with the local codes, or in the absence of local codes, with the National Electric Code and National Fuel Gas

Code, ANSI Z223 for gas dryers.

MINIMUM CLEARANCE OTHER THAN ALCOVE OR CLOSET

INSTALLATIONS:

Minimum clearances to combustible surfaces 0" both sides, 0" rear.

FOR MORE INFORMATION ON VENTING KITS AND

ACCESSORIES,

PLEASE CALL 1-800-GE-CARES.

54-1/2"

PEDESTAL DIMENSIONS

(IN INCHES)

GFP1528PNDG - DIAMOND GRAY

GFP1528PNRS - SAPPHIRE BLUE

GFP1528PNSN - SATIN NICKEL

GFP1528SNWW - WHITE

This optional 16" pedestal raises the door opening and height of the washer or dryer.

16"

28"

79-5/8

28-7/8"

For answers to your Monogram, GE Café ™ Series, GE Profile ™ Series or

GE Appliances product questions, visit our website at geappliances.com or call GE Answer Center ® Service, 800.626.2000.

Specification Created 9/19

GE Dryer Vent

GE Dryer Vent

GFD85GSSN/GSPN

GE ® 7.8 cu. ft. Capacity Front Load Gas Dryer with Steam

DRYER EXHAUSTING INFORMATION – METAL DUCT ONLY

For complete information, see installation instructions packed with your dryer.

DUCTING MATERIALS: For best performance, this dryer should be vented with 4” diameter all rigid metal exhaust duct. If rigid metal duct cannot be used, then UL-listed flexible metal (semi-rigid) ducting can be used (Kit WX08X10077). In special installations, it may be necessary to connect the dryer to the house vent using a flexible metal (foiltype) duct. A UL-listed flexible metal (foil-type) duct may be used ONLY in installations where rigid metal or flexible metal (semi-rigid) ducting cannot be used AND where a 4” diameter can be maintained throughout the entire length of the transition duct. Please see installation instruction packed with your dryer for complete instructions when using flexible metal (foil type) ducting.

EXHAUST LENGTH CALCULATION:

1. Determine the number of 90° turns needed for your installation. If you exhaust to the side or bottom of dryer, add one turn.

2. The maximum length of 4" rigid (aluminum or galvanized) duct which can be tolerated is shown in the table.

A turn of 45° or less may be ignored. Two 45° turns within the duct length should be treated as a 90° elbow.

A turn over 45° should be treated as a 90° elbow.

Dryers must be exhausted to the outside.

CAUTION: For personal safety do not terminate exhaust into a chimney, under any enclosed house floor (crawl space), or into an attic, since the accumulated lint could create a fire hazard or moisture could cause damage. Never terminate the exhaust into a common duct or plenum with a kitchen exhaust, since the combination of lint and grease could create a fire hazard.

Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts, bird nesting, etc. The wall cap must also be located at least 12" above the ground or any other obstruction with the opening pointed down.

FOR MORE INFORMATION ON VENTING KITS AND ACCESSORIES, PLEASE

CALL 1-800-GE-CARES.

5-3/8

A

A

A

4

4

B

B

Domestic dryer models

2-1/2

2-1/2

7.5 cu. ft.

capacity models electric dryers

1-5/8

11

Best performance

Maximum length of 4" dia. rigid metal duct

Exhaust hood type

Number of

90° turns

0

1

2

3

4

A

4" opening

90 ft.

60 ft.

45 ft.

35 ft.

25 ft.

B

2-1/2" opening

60 ft.

45 ft.

35 ft.

25 ft.

15 ft.

3-5/8

For answers to your Monogram, GE Café ™ Series, GE Profile ™ Series or

GE Appliances product questions, visit our website at geappliances.com or call GE Answer Center ® Service, 800.626.2000.

Specification Created 9/19

GFD85GSSN/GSPN

GE ® 7.8 cu. ft. Capacity Front Load Gas Dryer with Steam

FEATURES AND BENEFITS

Stainless steel drum – Enjoy premium durability with a drum that resists rust and helps protect clothes.

Washer Link – Wirelessly links your washer to your dryer so you only choose a setting once.

Powersteam – Refresh small loads and dewrinkle larger loads with the power of steam.

Built-in WiFi – Start, stop and monitor your laundry from anywhere while receiving real-time notifications and updates.

Quick Dry – Quickly dries items and small loads for families on the go.

Reduce Static – Helps remove static cling by spraying a gentle mist of steam near the end of the cycle.

Sanitize Cycle – Allows for a deeper clean with elevated temperatures designed to kill common household bacteria.

Wrinkle Care – Prevents wrinkles by extending the tumble without heat.

Damp Alert – Signals when delicate clothes reach the ideal dampness level for ironing or final air drying.

Model GFD85GSSNWW – White

Model GFD85GSPNDG – Diamond Gray

Model GFD85GSPNRS – Sapphire Blue

ADA

COMPLIANT

For answers to your Monogram, GE Café ™ Series, GE Profile ™ Series or

GE Appliances product questions, visit our website at geappliances.com or call GE Answer Center ® Service, 800.626.2000.

Specification Created 9/19

advertisement

Related manuals

Frequently Answers and Questions

What is the maximum length of the 4" rigid duct that can be used for this dryer?
The maximum length of the 4" rigid duct for this dryer depends on the number of 90° turns in the installation. If there are no 90° turns, the maximum length is 90 feet. If there is one 90° turn, the maximum length is 60 feet. If there are two 90° turns, the maximum length is 45 feet. If there are three 90° turns, the maximum length is 35 feet. And if there are four 90° turns, the maximum length is 25 feet.
What type of ducting materials are recommended for this dryer?
For best performance, this dryer should be vented with 4” diameter all rigid metal exhaust duct. If rigid metal duct cannot be used, then UL-listed flexible metal (semi-rigid) ducting can be used. In special installations, it may be necessary to connect the dryer to the house vent using a flexible metal (foil-type) duct. However, a UL-listed flexible metal (foil-type) duct may only be used in installations where rigid metal or flexible metal (semi-rigid) ducting cannot be used AND where a 4” diameter can be maintained throughout the entire length of the transition duct.
Does this dryer have a sanitization cycle?
Yes, this dryer has a Sanitize Cycle that allows for a deeper clean with elevated temperatures designed to kill common household bacteria.
What is the Washer Link feature on this dryer?
The Washer Link feature wirelessly links your washer to your dryer so you only have to choose a setting once. Once the washer cycle is complete, the dryer will automatically start the appropriate drying cycle based on the washer settings.
Does this dryer have a built-in WiFi?
Yes, this dryer has built-in WiFi that allows you to start, stop, and monitor your laundry from anywhere while receiving real-time notifications and updates.

advertisement