Antico Elements OUST-0507-SD, OUST-0507-LT, OUST-0507-ST, OUST-0507-GR, OUST-0507-GL, OUST-0507-CH, OUST-0507-CA, OUST-0508-BE, OUST-0507-CM, OUST-0507-DE Installation guide

Antico Elements OUST-0507-SD, OUST-0507-LT, OUST-0507-ST, OUST-0507-GR, OUST-0507-GL, OUST-0507-CH, OUST-0507-CA, OUST-0508-BE, OUST-0507-CM, OUST-0507-DE Installation guide
 Installation Of Switch And Outlet Trim.
Antico Elements’ Switch, Outlet and Fixture Trim Boxes are designed to move all electrical parts from the wall level to the stone
level and flush with the from of our stone product. This dramatically increase the realistic look of the project.
They can be installed VERTICALLY or HORIZONTALLY to accommodate for one or more fixtures. We have only one Switch
Trim product.
Before installations:
MAKE SURE TO CUT OFF ALL ELECTRICITY GOING TO THE SWITCHES AND RECEPTACLES.
Tools needed: ( same as wood cutting tools )
» Measuring tape and pencil
» Table saw, circular saw, miter saw, jig saw etc. You can use any blade designed for wood. Our material is very friendly.
e Nails or screws ( exterior grade if used outdoor and masonry screws for brick, concrete etc)
* Nail set
* Hammer (or screw driver/dril if using screws)
* Level
* Haming square
e Chalk line
« Construction adhesive, E.G: Liquid Nails, PL, etc.
* Safety Glasses
Instaling parts:
REMEMBER, you may click on the images below to enlarge them. Click the "Back" browser button to come back to this
page.
Start your panels and accessories installation as usual and pause when you are getting to an outlet, switch or fixture.
Lay your next panel by the switch.
Transfer the location of the switch on the the panel that will go in front of the it. Place the Switch Box in the center of that
measurement. With a penci race the outline of the Box onto the panel.
With a jig saw cut a hole around the pencil ine. We suggest cutting inside the pend line. The opening should line up with
existing switch. Try to slide the Switch Box in the opening to test the accuracy of the cut. It might need some sanding and
filing to make them fit
Fa
x PL TL e =
es |
Make sure to turn off the electricity going to the outlet. Cut a hole in the center of the Switch Box, large enough to pull
the switch through it. Make sure not to make the hole too big otherwise it might show around the face plate. Remove the face
plate and unscrew the switch from the electrical box.
You can now put some adhesive around he opening of the stone panel and slide the Switch Box through it.
Pull the Box in-out to make sure that al the exposed edges on the panels are covered by the box.
Use some nails or screws to hold the box in place. In some cases there may be the need for some caulking to close gaps
between the Box and the stone panels. If the color of the caulk doesn't match, you may always use one of our Touch-Up Kits.
Now you can install the face plate back.
If you have more than one switch or outlet you may install our Switch Trim horizontally to fit more of them. If you have a
very large fixture or multiple outlets / switches, you may combine two or more Switch Trim and make a larger one.
By rotating our Trim horizontally you should be able to house at least 2-3 switches.
For exterior application we suggest caulking the edges where water could penetrate.
Enjoy!
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement