ReliaBilt 3214VBSI, VBSI3218, 3218VBSI, 3222VBSI, VBSI3214 Installation guide

ReliaBilt 3214VBSI, VBSI3218, 3218VBSI, 3222VBSI, VBSI3214 Installation guide
WINDOW INSTALLATION INSTRUCTIONS
Insulated Slider Window
Installation Instructions
REQUIRED TOOLS
Replacement/New Construction
application for Insulated Slider Window
with installation/sealing flange
NOTE: Sealing flange can be scored and removed if needed
1/4 X 2-1/4” SCREWS FOR
MASONRY INSTALLATION
(not included)
OR
SEALANT
(not included)
8 X 2” SCREWS FOR
WOOD BUCK INSTALLATION
(not included)
DRILL
DRIVER
TAPE MEASURE
STEP 1. Center window in the opening. Make sure that the STEP 2. Secure window using 2-1/4” screws fastened
sash lock is positioned to the INSIDE of the structure.
through the pre-punched installation holes located on the side
Note: In tight installation applications the screen can be removed walls (as shown above).
from the window before installation for easier access to the
pre-drilled installation screw holes
STEP 3. Fill the gaps, interior, exterior and around the perimeter STEP 4. To insure proper water drainage keep weep holes
of the window between the mainframe and wall with an approved clear and free from obstruction (see above).
polyurethane based sealant such as Vulkem® or 100% silicone Fit the screen back into the window if it was removed prior to
window and door caulk.
installation. Trim and finish the interior and exterior as desired.
Caution, over use of expansion foam can make the window too
tight in the opening and can negatively impact the operation of
the window.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement