Model #1851 24"x36" Prism Rectangle

MOUNTING INSTRUCTIONS FOR MIRRORS

Parts List:

• 24” x 36” Prism Beveled Mirror w/ Mounting Brackets

• 12” Wall Mounting Clip

• 3 Plastic Wall Anchors

• 3 Screws.

• 1 Disposable Level

Tools Needed:

Pencil and Eraser, Drill and 3/16” Drill Bit,

Screw Gun or Driver with Phillips Head,

Tape Measure, Hammer and Friend to help.

(Two People are required to mount this mirror).

WARNING: Always wear safety goggles and gloves when handling glass. Handle mirror Carefully. DO NOT REMOVE-Plastic Protective

Corners until installation is complete. Do not bump mirror against hard surfaces. Place on towel or soft surface like carpet when handling.

READ INSTRUCTIONS CAREFULLY BEFORE STARTING.

MOUNTING INSTRUCTIONS

#1 Using a tape measure, check the location

where the mirror is to be installed. Be sure

the mirror will fit in the desired location.

Fig.1

Fig.2

4"

#2 Place the mirror on the wall in area chosen.

(Two people are needed for this task).

Position the mirror at the desired height in

the center of the location. With Pencil mark

a dot or line on the very top edge of the arch.

See Fig.1. Set mirror aside In safe place.

#3 From the dot made on the wall, using a

tape rule, measure down 4" and mark

the spot on the wall Fig. 2.

#4 From this spot, position the 12” Hanging Clip.

The top of the hanging clip should be centered

on the spot marked on the wall 4" from the top

of the mirror. Mark the locations for the screw

holes at the bottom of the clip, using the level to

make sure the clip is level and straight. Fig.3.

Set the clip and level aside.

Fig.3

#5 Using the Drill and 3/16” Drill Bit-Pre Drill the

holes for the wall anchors. Lightly tap the

plastic wall anchors into place with hammer.

#6 Reposition the 12” Clip and Bubble Level

and secure to the wall with the screws

provided. Check the level again to determine

that the clip is straight and level. (Fig.4)

Fig.4

Disposable

Level

#7 Carefully place the mirror with the mounting

plate onto the installed wall clip. Mirror can be

adjusted side to side by gently sliding the mirror along the clip.

With mirror centered installation is complete - you look marvelous.