Energizer ENB130A 1-Gauge 30 ft. Jumper Cables with Quick Connect Installation Guide

Energizer ENB130A 1-Gauge 30 ft. Jumper Cables with Quick Connect Installation Guide
INSTALLATION INSTRUCTIONS FOR PLUG-IN BOOSTER CABLES
3
For Top Mount Batteries
(ALL HARDWARE INCLUDED)
5
1. Remove bolts from service vehicle battery and
discard. Use new bolts included with the Booster
Cables.
2. Attach new Bolt(3), Spacer(5) and
Nut(4) for both pos. “+” and neg. “-” battery
terminal hook-ups as shown. Be careful to
attach the positive cable (the cable with the red
stripe on the terminal end) to the positive post on
the battery, as well as the negative cable to the
negative post.
4
3
EXISTING CABLES
5
4
PERMANENT
PLUG-IN BOOSTER CABLE
TO
STARTER
POS
For Side Mount Batteries
(ALL HARDWARE INCLUDED)
6
1. Remove bolts from service vehicle battery and
discard. Use new Bolt(6), Spacer(8) and
Nut(7) included with the Booster Cables.
2. Attach the battery cables with the new Bolts(6)
(one “screw-in-screw” side terminal bolt for each
terminal hook-up).
3. Attach booster cables to terminal bolt as shown
right. Be careful to attach the positive cable (the cable
with the red stripe on the terminal end) to the positive
post on the battery, as well as the negative cable to the
negative post.
TO
GROUND
NEG
DISCARD
6
8
7
SCREW-IN-SCREW
SIDE TERMINAL
BOLT
POS
NEG
Bolt(9) and Nut(10) are used for attaching the Plug-in Connector to the vehicle. Cap(2) is used for
protecting the Plug-in Connector from water and dust during storage.
PARTS LIST:
No.
Description
Qty
1
Booster cable
1
No.
Description
Qty
2
Cap
1
6&7
Screw-in-crew Side
Terminal Bolt
2
3
Bolt(M)
4
Nut(M)
2
8
Copper Spacer
2
2
9
Bolt(S)
5
Aluminum Spacer
2
2
10
Nut(S)
2
1
9
2
3
4
5
6
7
8
10
8
7
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement