Home Decorators Collection 66 in. L - 120 in. L Telescoping 3/4 in. Single Curtain Rod Kit installation Guide

DRAPERY ROD SET INSTALLATION GUIDE
Note:
Finial shown is for illustration purposes only.
It may not represent the style of finial purchased.
For larger width windows, two persons may be required for easier leveling.
Tools needed:
Tape Measure, Pencil, Drill & Bit Set, Philips head
Screwdriver, Level
Philipshead
Screwdriver
[90 “00
Tape Measure Pencil Drill & Bit Set Level
BRACKET INSTALLATION
STEP 1.
Place brackets against wall or ceiling at desired locations
and mark screw holes. Use tape measure and level to make
sure marked screw holes are horizontal to each other.
STEP 2A. (FOR MOUNTING TO DRYWALL, CEILING,
OR PANELING)
Pre-drill two pilot holes for each bracket ( 1/4” drill bit) and
insert anchors into wall/ceiling and insert screws into wall
anchors.
STEP 2B. (FOR MOUNTING TO WOOD OR STUDS)
If mounting directly into wood or studs, pre-drill two pilot
holes for each bracket ( 1/4” drill bit) and install bracket on
the wall with screws provided.
STEP 3.
Determine projection of brackets. Loosen projection screw,
slide bracket to desired position and tighten projection
screw. Repeat for each bracket.
ROD INSTALLATION
CEILING MOUNT
DRY WALL
STUDS
||
mo
/o) Г
STEP 4.
Detach finial from inner rod.
STEP 5.
Attach finial to extra outer rod. Assemble rod and
DRAPERY ——
shirr drapery treatment onto rod.
STEP 6.
Extend rod to desired width and place it into the brackets.
Adjust draperies to desired position.
FINAL ADJUSTMENT
STEP 7.
Secure each rod by tightening screws provided.