Noble House 300419 Installation guide

Noble House 300419 Installation guide
Caution : You must read this before you proceed
Reminder : Maximum diameter for open Umbrella - 70 inches
Umbrella Base
Umbrella Base Weight : 28lbs
Label
Picture
Description
QTY
A
Umbrella Base
1
B
Locking Bolt
1
C
Decorative Ring
1
D
Support Pole
1
Page 1 OF 5
E
Adjustable Screw
1
F
Cap
1
G
Adapter for 35mm Pole
1
H
Adapter for 38mm Pole
1
Before
Beginning
Assembly:
WARNING: CHOKING HAZARD. Do not allow children to play with plastic wraps or any
small parts in this package.
Notice: As a safety precaution, when your Umbrella is not in use, please close the
Umbrella.
Remove Umbrella from this Base and store in safe location
This Base is NOT suited and NOT recommended to be used as a free-standing
Umbrella Base.
This Base must be used under a matching table and matching Umbrella size.
ATTENTION: This Umbrella Base is exclusively recommended to be used together
under a table with the matching umbrella with diameter of 59 inches to 70 inches.
The matching Support Pole diameter: 35mm - 38mm.
Page 2 OF 5
(E)
This Umbrella Base has multiple parts and may require up to 30 minutes to
assemble. To give you an overview of the Umbrella Base parts, the above
picture is to help you put the various parts into perspective. Please read
through the instructions below to familiarise youself with the parts and steps
before assembly.
Step 1
This is a two person team assembly product.
Screw Locking Bolt(B) into the bottom of Support Pole(D).
Place Decretive Ring(C) on Umbrella Base(A), then screw the Locking Bolt(B) and Support Pole(C) into
Umbrella Base(A).
Page 3 OF 5
Step 2
Screw the Adjustable Screw(E) into the Support Pole(D).
Step 3 - A
Used for Umbrella Pole with 35mm diameter.
Insert Adapter for 38mm Pole(H) into the Support Pole(D) first, then put the Adapter for 35mm Pole(G)
onto the Adapter for 38mm Pole(H).
Turn the Cap(F) onto the Support Pole(D) to lock the Adapters in place.
Your Umbrella Base is ready for use.
This Umbrella Base only be used on a flat, level surface.
Step 3 - B
Used for Umbrella Pole with 38mm diameter.
Insert Adapter for 38mm Pole(H) into the Support Pole(D).
Turn the Cap(F) onto the Support Pole(D) to lock the Adapter in place.
Your Umbrella Base is ready for use.
This Umbrella Base only be used on a flat, level surface.
Page 4 OF 5
Page 5 OF 5
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement