Gibraltar Building Products FC2BRW 2 in. x 2 in. x 10 ft. Galvanized Steel Fascia Cap Flashing Installation guide

Add to my manuals
1 Pages

advertisement

Gibraltar Building Products FC2BRW 2 in. x 2 in. x 10 ft. Galvanized Steel Fascia Cap Flashing Installation guide | Manualzz

INSTALLATION GUIDELINES

FASCIA CAP FLASHING

12 in.

Grip Edge

Drip Edge

Install along the eaves, starting at a corner and working your way around. Hold the flashing tight against the fascia. Overlap each succeeding piece of roof starter flashing by 2-3 inches.

After the fascia cap flashing has been installed, apply the underlayment and/or ice-water barrier.

Depending on local building codes and wind conditions, fascia cap flashing should be nailed every 12".

Over Driven 1/32"

CAUTION!

Working above grade is inherently dangerous, be sure that proper fall protection measures are in place.

When working with power tools and sheet metal, gloves and eye protection are absolutely required.

These installation guidelines are for use with typical or standard applications. It is always recommended to seek advice from a licensed professional, and to check with your local building inspector or building permit office for approvals and possible variations that may apply.

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement