Arlo Blinds 04CF2340840, 04CF2284730, 04CF2480730, 04CF2384840, 04CF2264600, 04CF2340480, 04CF2464480, 04CF2630600, 04CF2230730, 04CF2200730 Manual

Arlo Blinds 04CF2340840, 04CF2284730, 04CF2480730, 04CF2384840, 04CF2264600, 04CF2340480, 04CF2464480, 04CF2630600, 04CF2230730, 04CF2200730 Manual
Mounting Instructions
2” Cordless Faux Wood Blind
Installation Instructions
Congratulations on purchasing one of the
best blinds on the market. You can take
pride that your purchase will enhance the
function and beauty of your home.
Components
Select the type of mount that
best suits your preference.
1) Inside mount: inside the
window frame.
2) Outside mount: outside the
window frame.
3) Overhead surface/ceiling
mount. The brackets should be
placed closer to the ends of the
headrail so that the headrail is
secured firmly to the brackets.
SUPPORT BRACKET
(Note: Support brackets are included for
blinds that have a width that is over 37".
Tools recommended for installation
Position the support brackets as
evenly as possible between the
mounting brackets so that the
blind is evenly secured.Make
sure the support bracket is in
line with the End Mounting
brackets.
INSERTING HEADRAIL
Insert the headrail into
the brackets and lock
the hinged flaps down
to hold the headrail in
position.
For an inside mount
installation, insert the
valance clips into the
valance groove located on
the backside of the valance.
Afterwards, make sure the
valance clip is securely
fastened to the headrail
before using your blind.
For an outside mount/ceiling mount installation, insert the
valance clips into the valance groove located on the
backside of the valance. Then attach the valance clip to
the headrail. Afterwards, insert the return clip into the
valance return. Note that the insert clip needs to attach to
the mitered (angle cut) side of the valance return for
proper installation. Finally, you have the option to attach
the valance return assembly to the valance ends for the
complete valance.
Hold Down Brackets(Optional)
Using two small screw, screw
hold down bracket to window
or wall . Snap bracletpin ends
into the hole at the bottom
rail end.
Note: the use of hold down
bracket is recommended but
is not a requirement for the
normal funtion of blind.
Once you finish the
installation, lower the blind
and check that the blind is
balanced.
Note: The blind should
not rebound and fall.
Keep your blind looking its best by periodically cleaning it with either a soft cloth, feather duster, dusting mitt or the brush attachment
from a vacuum cleaner. Please avoid using solvents or abrasive solutions to clean the blind since this may damage the blind.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement