MyMoldDetective MMD103A 3-Room Mold Test Kit Instructions

MyMoldDetective MMD103A 3-Room Mold Test Kit Instructions
 IMPORTANT TIP! Do not take air samples it it's raining. To ensure
accuracy, indoor and outdoor samples should be taken within a
15-minute period of each other.
Open accessory pack and remove air sample cassettes
and tape lift.”
For Air Sampling: You will be taking one outdoor air sample (used às a
control or baseline) and at least one indoor air sample,
(a) Mark one air sample cassette as
your outdoor sample by checking
the box that says “Outdoor”. The
outdoor sample location should be
taken in an open and clear area that
is 10 ft away from the structure
and overhangs. Once the outdoor
sample location has been identified,
place the pump on a sturdy surface approximately 3 to 5 ft off the ground
and ensure you have a power outlet to plug into (an extension cord may be
necessary). Mark the remaining air sample cassette with the room location
name to be sampled. The indoor sample should be taken in the middle of
the room and approximately 3 to 5 ft off the ground.
(b) Remove the tape quality seal
on BOTH the top and bottom of
the air sample cassette and press lid
clasp on the pump to open the lid.
(The lid will remain open while
pump is in operation.)
(c) Insert cassette on the air sample
inlet tray, secure firmly in place
and push the green button on the
front ofthe pump to start the air
sampling process. The pump will
take a 5-minute air sample and turn
off automatically.
(d) Reseal the tape on the top and
bottom of the cassette after the test
is complete, Repeat the process for
the indoor room sample.
For Surface Sampling:
(a) Identify the surface with (b) Peel off the cover slip
“suspect mold” growth to take your to expose the tacky surface of
surface sample. Write the location the tape.
name on the sample tape label.
(d) Close the tape onto the
white backer. For accurate
results only take one surface
sample per tape lift.
(c) Press thé tacky surface onto
the surface you want to sample.
and upload to your report during the registration process for
e IMPORTANT TIP! Take photos of your sampling in action
à more detailed report!
Once you have taken air and surface samples, log on to to complete registration.
(Note: No lab analysis will be completed unti registration and payment
are confirmed.)
Click the “Register Samples” button at the top of the home page and
follow the instructions. Finalize the registration process by paying for
the lab analysis. Make sure to write the confirmation number on the
front of the prepaid, seli-addressed envelope.
Insert air sample cassettes and tape lift into the prepaid,
self-addressed envelope.
For standard delivery, simply mail via USPS. For Express delivery, you
can overnight using the same address on the self-addressed envelope.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF