5. Refer to repair parts list below. Attach hitch bracket to drawbar with two 3/8" x 3/4" hex bolts and keps nuts as shown. Insert hitch pin and lock in place with hairpin provided.

REPAIR PARTS LIST

2

1

17

4

3

11

17

30

16

10

31

18

6

12

9

17

5

7

5

17

13

15

14

8

CAUTION:

READ AND FOLLOW

ALL SAFETY RULES

AND INSTRUCTIONS

BEFORE USING

THIS EQUIPMENT.

3460HATV

20 CU. FT. HEAPED CAPACITY

ALL TERRAIN CART

ASSEMBLY MANUAL AND PARTS LIST

2575 FERRIS ROAD

COLUMBUS, OHIO 43224-2597

3460HATV-REV-N/C 5/04

* denotes standard hardware item, can be purchased locally.

TOOLS REQUIRED

7/16" WRENCH AND SOCKET

9/16" WRENCH AND SOCKET

PLIERS

SAFETY INSTRUCTION

DO NOT CARRY PASSENGERS IN CART.

DO NOT TOW CART ON PUBLIC ROADS.

NEVER EXCEED LOAD CAPACITY - 1500LBS.

AVOID SUDDEN TURNS OR MANEUVERS.

WHEN OPERATING ON SLOPES, USE LOWEST

GROUND SPEED AND LIMIT LOAD TO 200LBS.

OPERATE UP AND DOWN SLOPES, NEVER

ACROSS THE FACE.

MAINTENANCE

CHECK TIRE PRESSURE REGULARLY.

PERIODICALLY CHECK ALL BOLTS.

KEEP CART CLEAN TO PREVENT RUST.

STORE INSIDE A CLEAN DRY AREA.

18

3/8" KEPS NUT

3/8" HEX BOLT

17

5

AXLE HOLDER

PLATES

7

AXLE

DRAWBAR

12

STEP 1.

4

FRONT SUPPORT

BACKING PLATE

18 3/8" KEPS NUT

3

FRONT SUPPORT

WELDMENT

1. Attach front support and front support backing plate to cart body as shown with three 3/8" x 3/4" hex head bolts and

3/8" keps nuts.

14

COTTER PIN

8

TIRE

15 AXLE SPACER

AXLE WASHER

13

13

15

AXLE SPACER

AXLE WASHER

17

3/8" HEX BOLT

STEP 2.

2. Loosely attach the four axle holder plates with the

3/8"x 3/4" hex head bolts provided. NOTE: these bolts will be tightened after axle and wheels are installed in a later step.

STEP 3.

3. Center drawbar tube between axle holder plates and insert axle, making sure to center axle so that wheels can be put on in the next step.

STEP 4.

COTTER PIN

14

4. Slide axle washer and axle spacer over each side of axle as shown. Add wheels making sure valve stem faces out. Insert cotter pin in axle and lock in place by spreading ends. Turn cart upright and add tailgate.