Retro Art DUNES502 Operating instructions

Retro Art DUNES502 Operating instructions
DUNES
(Interlocking wall panels)
DUNES
Adhesives
OR
OR
EN
General Information prior to installation :
1.
2.
3.
4.
Surface and panels must be clean, dry smooth and free of dust, grease, wax and or any other particales priot to installation
Clean the back surface of the panel, use a clean cloth and rubbing alcohol
Prepare a detailed plan, measure the area planned to be covered to determine how many panels you will need prior to cutting and installing.
Adhesives - Use high quality, strong, one component adhesive and sealant based on MS polymer 5
Installing the Panels :
Step 1:
Step 2:
Step 3:
Step 4:
Prepare a detailed plan, in accordance with your chosen option, measure the area planned to be covered prior to starting the installation.
Apply adhesive onto the high points at the panels’ back side.
Make sure you apply the adhesive on all spots as well as onto the overlap between the panels.
* Please pay attention to the connection between the panels, it is important to use an adhesive in the connection between the overlapping panels,
press the panels to the wall with your fingers and use a masking tape.
If the panels need cutting, please do so in advance using scissors or a utility knife.
After installing all the panels and applying masking tape in order to hold them in place, wait for 24 hours until the adhesive dries totally prior to
removing the masking tape.
1
2
Option 1:
4
3
2
1
Option 2:
4
3
2
1
GLUE
3
4
2
1
1
OR
5
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement