Whitehaus Collection WHS0111-SB-PSS Single Hole Single-Handle Lead Free Bathroom Faucet installation Guide

WAT=RHAUS
Installation Guide
WHS0111SB
Thank you for selecting this product!
IMPORTANT NOTICES: For easy installation, please read
all the instructions completely before beginning. Before
installing this product ,make sure that water lines are properly
flushed and cleared to avoid blockage.
WARNING: Assembly by a professional plumber is required.
YOU MAY NEED
INSTALLATION PROCEDURES
Clean all dirt and debris
from supply valves
before proceeding with
installation. If you are
replacing an existing
faucet, remove the faucet
from the sink and clean
the surface thoroughly.
aT
RL
Drill a @®1-3/8"to D1-1/2”
hole (2) in sink (1). Install
the shank (3) into the faucet
body (4). And screw them firmly.
Then put O-ring (5) into base
groove and insert the them
through the hole(2).
Ly
Adjust the faucet to the
right position and put on
the rubber gasket (7) and
the metal washer (8) and
lock nut (9),wrench them
up tightly.
в
Red hos, .
; hoi cold
Pull the handle upward in
horizontal to turn on the
faucet, downward in
horizontal line to turn off .
Face the spout, move the
handle leftward to control
hot water and rightward to
control cold water.
Check every joint to make
sure it has been connected
well. Open the pop-up then
turn on the water to check
the leakage.
Connect the flexible hoses
to the water supply valves
(left to hot water and right
to cold). Make sure flexible
hoses are securely fastened
before turning on valve.
CAUTION: Maintenance
1. Always turn off water and relieve pressure before working on your faucet.
NOTES: Cleaning Instructions
1. Clean the faucet with mild soap and water, then wipe the faucet dry with soft cloths.
2. Do not use cleaners which contain acids, harsh chemicals, or abrasives.
3. Repeat steps 1-2 whenever necessary.
| я
i] ==
ПИН ПОРОЙ
-—. M5
al ii EEE
Witohaus
TROUBLE-SHOOTING
If you've followed the instruction carefully and your faucet still does not
work properly, take these corrective steps.
Problem
Cause
Action
Leaks underneath handle.
Cartridge has come loose.
Tighten the cartridge.
Aerator leaks or has an
inconsistent water flow
pattern.
Aerator is dirty or worn
out or misfitted.
Unscrew the aerator to
clean or replace washer,
or replace the aerator.
Water will not shut off
completely.
Dirty or worn out washer
in cartridge.
Remove handle and cartridge
to check if the washer is damaged
permanently or dirty. Re-install
cartridge .
">